[PATCH] watchdog: bcm2835_wdt: set WDOG_HW_RUNNING bit when appropriate

[Rasmus Villemoes]

A bootloader may start the watchdog device before handing control to
the kernel - in that case, we should tell the kernel about it so the
watchdog framework can keep it alive until userspace opens
/dev/watchdog0.

Signed-off-by: Rasmus Villemoes <rasmus.villemoes at prevas.dk>
---
 drivers/watchdog/bcm2835_wdt.c | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/drivers/watchdog/bcm2835_wdt.c b/drivers/watchdog/bcm2835_wdt.c
index 4dddd82..c32c45b 100644
--- a/drivers/watchdog/bcm2835_wdt.c
+++ b/drivers/watchdog/bcm2835_wdt.c
@@ -55,6 +55,15 @@ struct bcm2835_wdt {
 static unsigned int heartbeat;
 static bool nowayout = WATCHDOG_NOWAYOUT;
 
+static bool bcm2835_wdt_is_running(struct bcm2835_wdt *wdt)
+{
+	uint32_t cur;
+
+	cur = readl(wdt->base + PM_RSTC);
+
+	return !!(cur & PM_RSTC_WRCFG_FULL_RESET);
+}
+
 static int bcm2835_wdt_start(struct watchdog_device *wdog)
 {
 	struct bcm2835_wdt *wdt = watchdog_get_drvdata(wdog);
@@ -181,6 +190,17 @@ static int bcm2835_wdt_probe(struct platform_device *pdev)
 	watchdog_init_timeout(&bcm2835_wdt_wdd, heartbeat, dev);
 	watchdog_set_nowayout(&bcm2835_wdt_wdd, nowayout);
 	bcm2835_wdt_wdd.parent = &pdev->dev;
+	if (bcm2835_wdt_is_running(wdt)) {
+		/*
+		 * The currently active timeout value (set by the
+		 * bootloader) may be different from the module
+		 * heartbeat parameter or the value in device
+		 * tree. But we just need to set WDOG_HW_RUNNING,
+		 * because then the framework will "immediately" ping
+		 * the device, updating the timeout.
+		 */
+		set_bit(WDOG_HW_RUNNING, &bcm2835_wdt_wdd.status);
+	}
 	err = watchdog_register_device(&bcm2835_wdt_wdd);
 	if (err) {
 		dev_err(dev, "Failed to register watchdog device");
-- 
2.7.4