[PATCH 07/12] ARM: dts: imx6-sabreauto: add reset-gpios property for max7310_b
Steve Longerbeam
slongerbeam at gmail.com
Wed Dec 7 16:57:48 PST 2016
The reset pin to the port expander chip (MAX7310) is controlled by a gpio,
so define a reset-gpios property to control it. There are three MAX7310's
on the SabreAuto CPU card (max7310_[abc]), but all use the same pin for
their reset. Since all can't acquire the same pin, assign it to max7310_b,
that chip is needed by more functions (usb and adv7180).
Signed-off-by: Steve Longerbeam <steve_longerbeam at mentor.com>
---
arch/arm/boot/dts/imx6qdl-sabreauto.dtsi | 9 +++++++++
1 file changed, 9 insertions(+)
diff --git a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
index 043d20c..944a4fa 100644
--- a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
@@ -136,6 +136,9 @@
reg = <0x32>;
gpio-controller;
#gpio-cells = <2>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_max7310>;
+ reset-gpios = <&gpio1 15 GPIO_ACTIVE_LOW>;
};
max7310_c: gpio at 34 {
@@ -442,6 +445,12 @@
>;
};
+ pinctrl_max7310: max7310grp {
+ fsl,pins = <
+ MX6QDL_PAD_SD2_DAT0__GPIO1_IO15 0x80000000
+ >;
+ };
+
pinctrl_pwm3: pwm1grp {
fsl,pins = <
MX6QDL_PAD_SD4_DAT1__PWM3_OUT 0x1b0b1
--
2.7.4
More information about the linux-arm-kernel
mailing list