[PATCH v4 3/7] PWM: add pwm-stm32 DT bindings
Benjamin Gaignard
benjamin.gaignard at linaro.org
Tue Dec 6 04:38:45 PST 2016
Define bindings for pwm-stm32
version 2:
- use parameters instead of compatible of handle the hardware configuration
Signed-off-by: Benjamin Gaignard <benjamin.gaignard at st.com>
---
.../devicetree/bindings/pwm/pwm-stm32.txt | 33 ++++++++++++++++++++++
1 file changed, 33 insertions(+)
create mode 100644 Documentation/devicetree/bindings/pwm/pwm-stm32.txt
diff --git a/Documentation/devicetree/bindings/pwm/pwm-stm32.txt b/Documentation/devicetree/bindings/pwm/pwm-stm32.txt
new file mode 100644
index 0000000..c0cc246
--- /dev/null
+++ b/Documentation/devicetree/bindings/pwm/pwm-stm32.txt
@@ -0,0 +1,33 @@
+STMicroelectronics STM32 General Purpose Timer PWM bindings
+
+Must be a sub-node of an STM32 General Purpose Timer device tree node.
+See ../mfd/stm32-general-purpose-timer.txt for details about the parent node.
+
+Required parameters:
+- compatible: Must be "st,stm32-pwm".
+- pinctrl-names: Set to "default".
+- pinctrl-0: List of phandles pointing to pin configuration nodes for PWM module.
+ For Pinctrl properties see ../pinctrl/pinctrl-bindings.txt
+
+Optional parameters:
+- st,breakinput-polarity: If present, a break input is available
+ for the channel. In that case the property value denotes the
+ polarity of the break input:
+ - 0: active low
+ - 1: active high
+
+Example:
+ gptimer at 40010000 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ compatible = "st,stm32-gptimer";
+ reg = <0x40010000 0x400>;
+ clocks = <&rcc 0 160>;
+ clock-names = "clk_int";
+
+ pwm at 0 {
+ compatible = "st,stm32-pwm";
+ pinctrl-0 = <&pwm1_pins>;
+ pinctrl-names = "default";
+ };
+ };
--
1.9.1
More information about the linux-arm-kernel
mailing list