[PATCH v2 3/7] dts: sun8i-h3: add i2c0/i2c1 SoC peripherals

[jorik at kippendief.biz]

From: Jorik Jonker <jorik at kippendief.biz>

This enables the i2c0/i2c1 peripherals of the SoC. There is actually a third
controller, but I do not have a board on hands on which i2c2 is exposed in such
a way that I can verify that it works.

Signed-off-by: Jorik Jonker <jorik at kippendief.biz>
---
 arch/arm/boot/dts/sun8i-h3.dtsi | 22 ++++++++++++++++++++++
 1 file changed, 22 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-h3.dtsi b/arch/arm/boot/dts/sun8i-h3.dtsi
index 0637b95..b4ce925 100644
--- a/arch/arm/boot/dts/sun8i-h3.dtsi
+++ b/arch/arm/boot/dts/sun8i-h3.dtsi
@@ -469,6 +469,28 @@
 			status = "disabled";
 		};
 
+		i2c0: i2c at 01c2ac00 {
+			compatible = "allwinner,sun6i-a31-i2c";
+			reg = <0x01c2ac00 0x400>;
+			interrupts = <GIC_SPI 6 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_I2C0>;
+			resets = <&ccu RST_BUS_I2C0>;
+			status = "disabled";
+			#address-cells = <1>;
+			#size-cells = <0>;
+		};
+
+		i2c1: i2c at 01c2b000 {
+			compatible = "allwinner,sun6i-a31-i2c";
+			reg = <0x01c2b000 0x400>;
+			interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_I2C1>;
+			resets = <&ccu RST_BUS_I2C1>;
+			status = "disabled";
+			#address-cells = <1>;
+			#size-cells = <0>;
+		};
+
 		gic: interrupt-controller at 01c81000 {
 			compatible = "arm,cortex-a7-gic", "arm,cortex-a15-gic";
 			reg = <0x01c81000 0x1000>,
-- 
2.7.4