[PATCH 1/4] ARM: dts: exynos: Enable HDMI for Arndale Octa board

[Milo Kim]

* Support HDMI display data channel
  I2C #2 is assigned for the HDMI DDC. It enables the EDID access.

* GPIO for HDMI hot plug detect
  GPX3_7 is used. The HPD awareness is done when the GPIO is active high and
  single ended.

* Enable HDMI block in Exynos5420
  HDMI PLL consumes 1.0V LDO6 (PVDD_ANAIP_1V0) and HDMI oscillator requires
  1.8V LDO7 (PVDD_ANAIP_1V8).

Cc: Inki Dae <inki.dae at samsung.com>
Cc: Joonyoung Shim <jy0922.shim at samsung.com>
Cc: Seung-Woo Kim <sw0312.kim at samsung.com>
Cc: Rob Herring <robh+dt at kernel.org>
Cc: devicetree at vger.kernel.org
Cc: linux-arm-kernel at lists.infradead.org
Cc: linux-samsung-soc at vger.kernel.org
Cc: linux-kernel at vger.kernel.org
Cc: dri-devel at lists.freedesktop.org
Signed-off-by: Milo Kim <woogyom.kim at gmail.com>
---
 arch/arm/boot/dts/exynos5420-arndale-octa.dts | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/arch/arm/boot/dts/exynos5420-arndale-octa.dts b/arch/arm/boot/dts/exynos5420-arndale-octa.dts
index 39a3b81..df362a2 100644
--- a/arch/arm/boot/dts/exynos5420-arndale-octa.dts
+++ b/arch/arm/boot/dts/exynos5420-arndale-octa.dts
@@ -70,6 +70,23 @@
 	status = "disabled";
 };
 
+&i2c_2 {
+	samsung,i2c-slave-addr = <0x50>;
+	status = "okay";
+
+	hdmiddc at 50 {
+		compatible = "samsung,exynos4210-hdmiddc";
+		reg = <0x50>;
+	};
+};
+
+&hdmi {
+	hpd-gpios = <&gpx3 7 GPIO_OPEN_SOURCE>;
+	vdd_osc-supply = <&ldo7_reg>;
+	vdd_pll-supply = <&ldo6_reg>;
+	status = "okay";
+};
+
 &hsi2c_4 {
 	status = "okay";
 
-- 
1.9.1