[PATCH 9/9] ARM: dts: sun9i: a80-optimus: Disable EHCI1

[Chen-Yu Tsai]

EHCI1 provides an HSIC interface. This interface is exposed on the
board through two pins among the GPIO header.

With the PHY now powered up and responding, enabling the interface when
nothing is connected results in a lot of error messages:

	usb 2-1: device descriptor read/64, error -71
	usb 2-1: device descriptor read/64, error -71
	usb 2-1: new high-speed USB device number 3 using ehci-platform
	usb 2-1: device descriptor read/64, error -71
	usb 2-1: device descriptor read/64, error -71
	usb 2-1: new high-speed USB device number 4 using ehci-platform
	usb 2-1: device not accepting address 4, error -71
	usb 2-1: new high-speed USB device number 5 using ehci-platform
	usb 2-1: device not accepting address 5, error -71
	usb usb2-port1: unable to enumerate USB device

Disable it by default, but leave the entries in the board DTS.

Signed-off-by: Chen-Yu Tsai <wens at csie.org>
---
 arch/arm/boot/dts/sun9i-a80-optimus.dts | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/sun9i-a80-optimus.dts b/arch/arm/boot/dts/sun9i-a80-optimus.dts
index aeb4037c8768..536a7d1d678b 100644
--- a/arch/arm/boot/dts/sun9i-a80-optimus.dts
+++ b/arch/arm/boot/dts/sun9i-a80-optimus.dts
@@ -112,7 +112,8 @@
 };
 
 &ehci1 {
-	status = "okay";
+	/* Enable if HSIC peripheral is connected */
+	status = "disabled";
 };
 
 &ehci2 {
@@ -484,7 +485,8 @@
 
 &usbphy2 {
 	phy-supply = <&reg_bldo4>;
-	status = "okay";
+	/* Enable if HSIC peripheral is connected */
+	status = "disabled";
 };
 
 &usbphy3 {
-- 
2.9.3