[PATCH v3 0/4] Add DT support for NAND to LCDK via ti-aemif

[Karl Beldan]

Hi,

Here is another spin. I could get my hands on an EVM and test the
changes on it as well. Doing so, I could also observe that 4bit ECC
on 8bits NANDS is currently broken in mailine. Apparently there had
already been some alerts on the mailing list some months ago.

Rgds, 
Karl

Changes from v1:
 - s/cs2/cs3
 - kept "ti,.." only nand properties (the adjustments made by
   nand_davinci_probe are broken)
 - replaced v1_1/4:
     "memory: ti-aemif: Get a named clock rather than an unnamed one"
   with v2_1/4:
     "davinci: da8xx-dt: Add ti-aemif lookup for clock matching"
 - Make the same improvements for the EVM as well as asked by Sekhar

Changes from v2:
 - remove now useless pins of nand_cs3 in v3_3/4


Karl Beldan (4):
  ARM: davinci: da8xx-dt: Add ti-aemif lookup for clock matching
  ARM: davinci_all_defconfig: Enable AEMIF as a module
  ARM: dts: da850,da850-evm: Add an aemif node and use it for the NAND
  ARM: dts: da850-lcdk: Add NAND to DT

 arch/arm/boot/dts/da850-evm.dts        |  49 +++++++++++++--
 arch/arm/boot/dts/da850-lcdk.dts       | 108 +++++++++++++++++++++++++++++++++
 arch/arm/boot/dts/da850.dtsi           |  35 +++--------
 arch/arm/configs/davinci_all_defconfig |   2 +
 arch/arm/mach-davinci/da850.c          |   1 +
 arch/arm/mach-davinci/da8xx-dt.c       |   1 +
 6 files changed, 164 insertions(+), 32 deletions(-)

-- 
2.9.2