[PATCH] ARM: dts: add PM8058 LEDs to the APQ8060 Dragonboard
Linus Walleij
linus.walleij at linaro.org
Tue Aug 16 12:45:59 PDT 2016
This adds the PM8058 LEDs as used in the platform.
Cc: linux-arm-msm at vger.kernel.org
Cc: linux-leds at vger.kernel.org
Cc: Andy Gross <andy.gross at linaro.org>
Cc: Stephen Boyd <sboyd at codeaurora.org>
Cc: Bjorn Andersson <bjorn.andersson at linaro.org>
Cc: Jacek Anaszewski <j.anaszewski at samsung.com>
Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
---
These DT bindings have been ACKed by Rob Herring and Bjorn Andersson
so I think the patch is safe to merge to the Qcom tree.
---
arch/arm/boot/dts/qcom-apq8060-dragonboard.dts | 39 ++++++++++++++++++++++++++
1 file changed, 39 insertions(+)
diff --git a/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts b/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts
index 0abc93e5bb00..b0800b988174 100644
--- a/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts
+++ b/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts
@@ -239,6 +239,45 @@
};
};
};
+
+ led at 48 {
+ /*
+ * The keypad LED @0x48 is routed to
+ * the sensor board where it is
+ * connected to an infrared LED
+ * SFH4650 (60mW, @850nm) next to the
+ * ambient light and proximity sensor
+ * Capella Microsystems CM3605.
+ */
+ compatible = "qcom,pm8058-keypad-led";
+ reg = <0x48>;
+ label = "proximity0";
+ default-state = "off";
+ };
+ led at 131 {
+ compatible = "qcom,pm8058-led";
+ reg = <0x131>;
+ label = "pm8058:red";
+ default-state = "off";
+ };
+ led at 132 {
+ /*
+ * This is actually green too on my
+ * board, but documented as yellow.
+ */
+ compatible = "qcom,pm8058-led";
+ reg = <0x132>;
+ label = "pm8058:yellow";
+ default-state = "off";
+ linux,default-trigger = "mmc0";
+ };
+ led at 133 {
+ compatible = "qcom,pm8058-led";
+ reg = <0x133>;
+ label = "pm8058:green";
+ default-state = "on";
+ linux,default-trigger = "heartbeat";
+ };
};
};
--
2.7.4
More information about the linux-arm-kernel
mailing list