[PATCH 21/21] net: thunderx: Don't set RX_PACKET_DIS while initializing
sunil.kovvuri at gmail.com
sunil.kovvuri at gmail.com
Tue Aug 9 23:42:53 PDT 2016
From: Sunil Goutham <sgoutham at cavium.com>
Setting BGXX_SPUX_MISC_CONTROL::RX_PACKET_DIS is not needed as
packet reception is anyway disabled by BGXX_CMRX_CONFIG::DATA_PKT_RX_EN.
Also setting RX_PACKET_DIS causes a bogus remote fault condition
which delays link detection.
Signed-off-by: Sunil Goutham <sgoutham at cavium.com>
---
drivers/net/ethernet/cavium/thunder/thunder_bgx.c | 18 +++++++-----------
1 file changed, 7 insertions(+), 11 deletions(-)
diff --git a/drivers/net/ethernet/cavium/thunder/thunder_bgx.c b/drivers/net/ethernet/cavium/thunder/thunder_bgx.c
index ca58d7f..8bbaedb 100644
--- a/drivers/net/ethernet/cavium/thunder/thunder_bgx.c
+++ b/drivers/net/ethernet/cavium/thunder/thunder_bgx.c
@@ -459,12 +459,14 @@ static int bgx_lmac_xaui_init(struct bgx *bgx, struct lmac *lmac)
bgx_reg_modify(bgx, lmacid, BGX_SPUX_CONTROL1, SPU_CTL_LOW_POWER);
/* Set interleaved running disparity for RXAUI */
- if (lmac->lmac_type != BGX_MODE_RXAUI)
- bgx_reg_modify(bgx, lmacid,
- BGX_SPUX_MISC_CONTROL, SPU_MISC_CTL_RX_DIS);
- else
+ if (lmac->lmac_type == BGX_MODE_RXAUI)
bgx_reg_modify(bgx, lmacid, BGX_SPUX_MISC_CONTROL,
- SPU_MISC_CTL_RX_DIS | SPU_MISC_CTL_INTLV_RDISP);
+ SPU_MISC_CTL_INTLV_RDISP);
+
+ /* Clear receive packet disable */
+ cfg = bgx_reg_read(bgx, lmacid, BGX_SPUX_MISC_CONTROL);
+ cfg &= ~SPU_MISC_CTL_RX_DIS;
+ bgx_reg_write(bgx, lmacid, BGX_SPUX_MISC_CONTROL, cfg);
/* clear all interrupts */
cfg = bgx_reg_read(bgx, lmacid, BGX_SMUX_RX_INT);
@@ -537,7 +539,6 @@ static int bgx_xaui_check_link(struct lmac *lmac)
int lmac_type = lmac->lmac_type;
u64 cfg;
- bgx_reg_modify(bgx, lmacid, BGX_SPUX_MISC_CONTROL, SPU_MISC_CTL_RX_DIS);
if (lmac->use_training) {
cfg = bgx_reg_read(bgx, lmacid, BGX_SPUX_INT);
if (!(cfg & (1ull << 13))) {
@@ -607,11 +608,6 @@ static int bgx_xaui_check_link(struct lmac *lmac)
return -1;
}
- /* Clear receive packet disable */
- cfg = bgx_reg_read(bgx, lmacid, BGX_SPUX_MISC_CONTROL);
- cfg &= ~SPU_MISC_CTL_RX_DIS;
- bgx_reg_write(bgx, lmacid, BGX_SPUX_MISC_CONTROL, cfg);
-
/* Check for MAC RX faults */
cfg = bgx_reg_read(bgx, lmacid, BGX_SMUX_RX_CTL);
/* 0 - Link is okay, 1 - Local fault, 2 - Remote fault */
--
2.7.4
More information about the linux-arm-kernel
mailing list