[PATCH v4 7/7] doc: bindings: act8945a-charger: Update properties

[Wenyou Yang]

Due the driver improvements, update the properties,
 - Remove "active-semi,check-battery-temperature" property.
 - Add the properties, "active-semi,irq_gpio"
   and "active-semi,lbo-gpios".

Signed-off-by: Wenyou Yang <wenyou.yang at atmel.com>
---

Changes in v4:
 - Update the doc/binding for using "interrupts" property.

Changes in v3: None
Changes in v2: None

 .../devicetree/bindings/power/act8945a-charger.txt       | 16 +++++++++++++---
 1 file changed, 13 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/power/act8945a-charger.txt b/Documentation/devicetree/bindings/power/act8945a-charger.txt
index bea254c..f9866c4 100644
--- a/Documentation/devicetree/bindings/power/act8945a-charger.txt
+++ b/Documentation/devicetree/bindings/power/act8945a-charger.txt
@@ -4,10 +4,15 @@ Required properties:
  - compatible: "active-semi,act8945a", please refer to ../mfd/act8945a.txt.
  - active-semi,chglev-gpios: charge current level phandle with args
    as described in ../gpio/gpio.txt.
+ - active-semi,lbo-gpios: specify the low battery voltage detect phandle
+   with args as as described in ../gpio/gpio.txt.
+ - interrupts: <a b> where a is the interrupt number and b is a
+   field that represents an encoding of the sense and level
+   information for the interrupt.
+ - interrupt-parent: the phandle for the interrupt controller that
+   services interrupts for this device.
 
 Optional properties:
- - active-semi,check-battery-temperature: boolean to check the battery
-   temperature or not.
  - active-semi,input-voltage-threshold-microvolt: unit: mV;
    Specifies the charger's input over-voltage threshold value;
    The value can be: 6600, 7000, 7500, 8000; default: 6600
@@ -27,9 +32,14 @@ Example:
 		status = "okay";
 
 		pinctrl-names = "default";
-		pinctrl-0 = <&pinctrl_charger_chglev>;
+		pinctrl-0 = <&pinctrl_charger_chglev &pinctrl_charger_lbo &pinctrl_charger_irq>;
+
 		active-semi,chglev-gpios = <&pioA 12 GPIO_ACTIVE_HIGH>;
+		active-semi,lbo-gpios = <&pioA 72 GPIO_ACTIVE_LOW>;
 		active-semi,input-voltage-threshold-microvolt = <6600>;
 		active-semi,precondition-timeout = <40>;
 		active-semi,total-timeout = <3>;
+		interrupt-parent = <&pioA>;
+		interrupts = <45 GPIO_ACTIVE_LOW>;
+
 	};
-- 
2.7.4