[RFC v4 5/8] gpio: ge: integrate GE's FPGA GPIO into gpio-mmio
Christian Lamparter
chunkeey at googlemail.com
Thu Apr 28 02:05:15 PDT 2016
This patch integrates the gpio-ge driver into the
gpio-mmio framework.
Signed-off-by: Christian Lamparter <chunkeey at googlemail.com>
---
drivers/gpio/Kconfig | 24 +++++-----
drivers/gpio/Makefile | 2 +-
drivers/gpio/gpio-ge.c | 101 ++++++++++++----------------------------
drivers/gpio/gpio-mmio-compat.h | 14 ++++++
drivers/gpio/gpio-mmio.c | 1 +
5 files changed, 57 insertions(+), 85 deletions(-)
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index ff9ac65..a0e140d 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -187,18 +187,6 @@ config GPIO_ETRAXFS
help
Say yes here to support the GPIO controller on Axis ETRAX FS SoCs.
-config GPIO_GE_FPGA
- bool "GE FPGA based GPIO"
- depends on GE_FPGA
- select GPIO_GENERIC
- help
- Support for common GPIO functionality provided on some GE Single Board
- Computers.
-
- This driver provides basic support (configure as input or output, read
- and write pin state) for GPIO implemented in a number of GE single
- board computers.
-
config GPIO_GENERIC_PLATFORM
tristate "Generic memory-mapped GPIO controller support (MMIO platform device)"
select GPIO_GENERIC
@@ -213,6 +201,18 @@ config GPIO_CLPS711X
help
Say yes here to support GPIO on CLPS711X SoCs.
+config GPIO_GE_FPGA
+ bool "GE FPGA based GPIO"
+ depends on GE_FPGA || COMPILE_TEST
+ select GPIO_GENERIC
+ help
+ Support for common GPIO functionality provided on some GE Single Board
+ Computers.
+
+ This driver provides basic support (configure as input or output, read
+ and write pin state) for GPIO implemented in a number of GE single
+ board computers.
+
endif
config GPIO_GRGPIO
diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
index a1ae48f..a76b13d 100644
--- a/drivers/gpio/Makefile
+++ b/drivers/gpio/Makefile
@@ -15,6 +15,7 @@ obj-$(CONFIG_GPIO_GENERIC) += gpio-generic.o
# directly supported by gpio-generic
gpio-generic-$(CONFIG_GPIO_GENERIC) += gpio-mmio.o
gpio-generic-$(CONFIG_GPIO_CLPS711X) += gpio-clps711x.o
+gpio-generic-$(CONFIG_GPIO_GE_FPGA) += gpio-ge.o
obj-$(CONFIG_GPIO_104_DIO_48E) += gpio-104-dio-48e.o
obj-$(CONFIG_GPIO_104_IDIO_16) += gpio-104-idio-16.o
@@ -43,7 +44,6 @@ obj-$(CONFIG_GPIO_EM) += gpio-em.o
obj-$(CONFIG_GPIO_EP93XX) += gpio-ep93xx.o
obj-$(CONFIG_GPIO_ETRAXFS) += gpio-etraxfs.o
obj-$(CONFIG_GPIO_F7188X) += gpio-f7188x.o
-obj-$(CONFIG_GPIO_GE_FPGA) += gpio-ge.o
obj-$(CONFIG_GPIO_GRGPIO) += gpio-grgpio.o
obj-$(CONFIG_GPIO_ICH) += gpio-ich.o
obj-$(CONFIG_GPIO_IOP) += gpio-iop.o
diff --git a/drivers/gpio/gpio-ge.c b/drivers/gpio/gpio-ge.c
index 8650b29..63cea89 100644
--- a/drivers/gpio/gpio-ge.c
+++ b/drivers/gpio/gpio-ge.c
@@ -18,13 +18,12 @@
*/
#include <linux/kernel.h>
-#include <linux/io.h>
-#include <linux/slab.h>
-#include <linux/of_device.h>
-#include <linux/of_gpio.h>
-#include <linux/of_address.h>
#include <linux/module.h>
+#include <linux/err.h>
+#include <linux/ioport.h>
#include <linux/gpio/driver.h>
+#include <linux/platform_device.h>
+#include "gpio-mmio-compat.h"
#define GEF_GPIO_DIRECT 0x00
#define GEF_GPIO_IN 0x04
@@ -36,79 +35,37 @@
#define GEF_GPIO_OVERRUN 0x1C
#define GEF_GPIO_MODE 0x20
-static const struct of_device_id gef_gpio_ids[] = {
- {
- .compatible = "gef,sbc610-gpio",
- .data = (void *)19,
- }, {
- .compatible = "gef,sbc310-gpio",
- .data = (void *)6,
- }, {
- .compatible = "ge,imp3a-gpio",
- .data = (void *)16,
- },
- { }
-};
-MODULE_DEVICE_TABLE(of, gef_gpio_ids);
-
-static int __init gef_gpio_probe(struct platform_device *pdev)
+int ge_parse_dt(struct platform_device *pdev,
+ struct bgpio_pdata *pdata,
+ unsigned long *flags)
{
- const struct of_device_id *of_id =
- of_match_device(gef_gpio_ids, &pdev->dev);
- struct gpio_chip *gc;
- void __iomem *regs;
- int ret;
-
- gc = devm_kzalloc(&pdev->dev, sizeof(*gc), GFP_KERNEL);
- if (!gc)
- return -ENOMEM;
-
- regs = of_iomap(pdev->dev.of_node, 0);
- if (!regs)
- return -ENOMEM;
-
- ret = bgpio_init(gc, &pdev->dev, 4, regs + GEF_GPIO_IN,
- regs + GEF_GPIO_OUT, NULL, NULL,
- regs + GEF_GPIO_DIRECT, BGPIOF_BIG_ENDIAN_BYTE_ORDER);
- if (ret) {
- dev_err(&pdev->dev, "bgpio_init failed\n");
- goto err0;
- }
+ struct device_node *np = pdev->dev.of_node;
- /* Setup pointers to chip functions */
- gc->label = devm_kstrdup(&pdev->dev, pdev->dev.of_node->full_name,
- GFP_KERNEL);
- if (!gc->label) {
- ret = -ENOMEM;
- goto err0;
- }
+ struct resource *res;
+ struct resource nres[] = {
+ DEFINE_RES_MEM_NAMED(0, 1, "dat"),
+ DEFINE_RES_MEM_NAMED(0, 1, "set"),
+ DEFINE_RES_MEM_NAMED(0, 1, "dirin"),
+ };
- gc->base = -1;
- gc->ngpio = (u16)(uintptr_t)of_id->data;
- gc->of_gpio_n_cells = 2;
- gc->of_node = pdev->dev.of_node;
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ if (!res || resource_size(res) != 0x24)
+ return -EINVAL;
- /* This function adds a memory mapped GPIO chip */
- ret = devm_gpiochip_add_data(&pdev->dev, gc, NULL);
- if (ret)
- goto err0;
+ set_resource_address(&nres[0], res->start + GEF_GPIO_IN, 0x4);
+ set_resource_address(&nres[1], res->start + GEF_GPIO_OUT, 0x4);
+ set_resource_address(&nres[2], res->start + GEF_GPIO_DIRECT, 0x4);
+ *flags |= BGPIOF_BIG_ENDIAN_BYTE_ORDER;
- return 0;
-err0:
- iounmap(regs);
- pr_err("%s: GPIO chip registration failed\n",
- pdev->dev.of_node->full_name);
- return ret;
-};
+ if (of_device_is_compatible(np, "ge,imp3a-gpio"))
+ pdata->ngpio = 16;
+ else if (of_device_is_compatible(np, "gef,sbc310-gpio"))
+ pdata->ngpio = 6;
+ else if (of_device_is_compatible(np, "gef,sbc610-gpio"))
+ pdata->ngpio = 19;
-static struct platform_driver gef_gpio_driver = {
- .driver = {
- .name = "gef-gpio",
- .of_match_table = gef_gpio_ids,
- },
-};
-module_platform_driver_probe(gef_gpio_driver, gef_gpio_probe);
+ return platform_device_add_resources(pdev, nres, ARRAY_SIZE(nres));
+}
MODULE_DESCRIPTION("GE I/O FPGA GPIO driver");
MODULE_AUTHOR("Martyn Welch <martyn.welch at ge.com");
-MODULE_LICENSE("GPL");
diff --git a/drivers/gpio/gpio-mmio-compat.h b/drivers/gpio/gpio-mmio-compat.h
index 32b5510..63863da 100644
--- a/drivers/gpio/gpio-mmio-compat.h
+++ b/drivers/gpio/gpio-mmio-compat.h
@@ -16,6 +16,20 @@ int cirrus_clps711x_parse_dt(struct platform_device *pdev,
#define GPIO_CLPS711X_COMPATIBLE
#endif /* CONFIG_GPIO_CLPS711X */
+#if IS_ENABLED(CONFIG_GPIO_GE_FPGA)
+int ge_parse_dt(struct platform_device *pdev,
+ struct bgpio_pdata *pdata,
+ unsigned long *flags);
+
+#define GPIO_GE_FPGA_COMPATIBLE \
+ ADD("ge,imp3a-gpio", ge_parse_dt), \
+ ADD("gef,sbc310-gpio", ge_parse_dt), \
+ ADD("gef,sbc610-gpio", ge_parse_dt),
+
+#else
+#define GPIO_GE_FPGA_COMPATIBLE
+#endif /* CONFIG_CONFIG_GPIO_GE_FPGA */
+
#undef ADD
static inline void set_resource_address(struct resource *res,
diff --git a/drivers/gpio/gpio-mmio.c b/drivers/gpio/gpio-mmio.c
index 1be8cb7..81af498 100644
--- a/drivers/gpio/gpio-mmio.c
+++ b/drivers/gpio/gpio-mmio.c
@@ -609,6 +609,7 @@ static int bgpio_basic_mmio_parse_dt(struct platform_device *pdev,
static const struct of_device_id bgpio_of_match[] = {
ADD("linux,gpio-mmio", bgpio_basic_mmio_parse_dt),
GPIO_CLPS711X_COMPATIBLE
+ GPIO_GE_FPGA_COMPATIBLE
{ }
};
--
2.8.1
More information about the linux-arm-kernel
mailing list