[PATCH 1/4] i2c: designware-platdrv: Fix runtime PM initialization

[Jisheng Zhang]

Dear Jarkko,

On Wed, 20 Apr 2016 16:53:08 +0300 Jarkko Nikula wrote:

> On 04/14/2016 03:53 PM, Jisheng Zhang wrote:
> > When pm_runtime_enable() was being called, the device's usage counter
> > was 0, causing the PM layer to runtime-suspend the device.  We then
> > went on to call i2c_dw_probe() on a suspended device, which could hung.
> >
> > Fix this by incrementing the usage counter before pm_runtime_enable().
> >
> > Signed-off-by: Jisheng Zhang <jszhang at marvell.com>
> > ---
> >   drivers/i2c/busses/i2c-designware-platdrv.c | 14 +++++++++++++-
> >   1 file changed, 13 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/i2c/busses/i2c-designware-platdrv.c b/drivers/i2c/busses/i2c-designware-platdrv.c
> > index d656657..00f9e99 100644
> > --- a/drivers/i2c/busses/i2c-designware-platdrv.c
> > +++ b/drivers/i2c/busses/i2c-designware-platdrv.c
> > @@ -246,6 +246,7 @@ static int dw_i2c_plat_probe(struct platform_device *pdev)
> >   	if (dev->pm_runtime_disabled) {
> >   		pm_runtime_forbid(&pdev->dev);
> >   	} else {
> > +		pm_runtime_get_noresume(&pdev->dev);
> >   		pm_runtime_set_autosuspend_delay(&pdev->dev, 1000);
> >   		pm_runtime_use_autosuspend(&pdev->dev);
> >   		pm_runtime_set_active(&pdev->dev);  
> 
> pm_runtime_enable() here after pm_runtime_set_active() shouldn't suspend 
> as far as I understand which made me thinking if there is some other 

FWICT, on arm DT platform, the device usage counter is zero at the beginning,
once we enable rpm, the i2c have chance to runtime suspend.

Thanks,
Jisheng

> issue that cause the symptoms what you are seeing? Like race with 
> runtime PM or similar.
>