[PATCH 14/14] regulator: ti-abb: DT spelling s/#{address, size}-cell/#{address, size}-cells/

Geert Uytterhoeven geert+renesas at glider.be
Wed Apr 20 08:32:19 PDT 2016


Signed-off-by: Geert Uytterhoeven <geert+renesas at glider.be>
---
 .../devicetree/bindings/regulator/ti-abb-regulator.txt         | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/Documentation/devicetree/bindings/regulator/ti-abb-regulator.txt b/Documentation/devicetree/bindings/regulator/ti-abb-regulator.txt
index c58db75f959e601f..c3f6546ebac77742 100644
--- a/Documentation/devicetree/bindings/regulator/ti-abb-regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/ti-abb-regulator.txt
@@ -14,8 +14,8 @@ Required Properties:
   - "setup-address"	- contains setup register address of ABB module (ti,abb-v3)
   - "int-address"	- contains address of interrupt register for ABB module
   (also see Optional properties)
-- #address-cell: should be 0
-- #size-cell: should be 0
+- #address-cells: should be 0
+- #size-cells: should be 0
 - clocks: should point to the clock node used by ABB module
 - ti,settling-time: Settling time in uSecs from SoC documentation for ABB module
 	to settle down(target time for SR2_WTCNT_VALUE).
@@ -69,7 +69,7 @@ Example #1: Simplest configuration (no efuse data, hard coded ABB table):
 abb_x: regulator-abb-x {
 	compatible = "ti,abb-v1";
 	regulator-name = "abb_x";
-	#address-cell = <0>;
+	#address-cells = <0>;
 	#size-cells = <0>;
 	reg = <0x483072f0 0x8>, <0x48306818 0x4>;
 	reg-names = "base-address", "int-address";
@@ -89,7 +89,7 @@ Example #2: Efuse bits contain ABB mode setting (no LDO override capability)
 abb_y: regulator-abb-y {
 	compatible = "ti,abb-v2";
 	regulator-name = "abb_y";
-	#address-cell = <0>;
+	#address-cells = <0>;
 	#size-cells = <0>;
 	reg = <0x4a307bd0 0x8>, <0x4a306014 0x4>, <0x4A002268 0x8>;
 	reg-names = "base-address", "int-address", "efuse-address";
@@ -110,7 +110,7 @@ Example #3: Efuse bits contain ABB mode setting and LDO override capability
 abb_z: regulator-abb-z {
 	compatible = "ti,abb-v2";
 	regulator-name = "abb_z";
-	#address-cell = <0>;
+	#address-cells = <0>;
 	#size-cells = <0>;
 	reg = <0x4ae07ce4 0x8>, <0x4ae06010 0x4>,
 	      <0x4a002194 0x8>, <0x4ae0C314 0x4>;
-- 
1.9.1




More information about the linux-arm-kernel mailing list