[PATCH 0/8] STMPE fixes/rework and add STMPE1600 support

[patrice.chotard at st.com]

From: Patrice Chotard <patrice.chotard at st.com>

This series cleans and fixes some bugs in MFD/GPIO STMPE drivers and prepare
 the ground to add new STMPE1600 support.

STMPE1600 datasheet is available here : 
http://www2.st.com/content/st_com/en/products/interfaces-and-transceivers/
i-o-expanders-and-level-translators/i-o-expanders/stmpe1600.html

Only STMPE1600 has been tested on STM32 platform. As i have no board with
others STMPE variant(STMPE610/STMPE801/STMPE811/STMPE1601/STMPE1801/STMPE2401
and STMPE2403), i put in CC boards's maintainers which are using others STMPE variant.

If they can kindly check that no regression has been introduce by this series
:

For ARM/FREESCALE IMX / MXC ARM ARCHITECTURE:
	_ Shawn Guo <shawnguo at kernel.org>
	_ Sascha Hauer <kernel at pengutronix.de>

For ARM/SOCFPGA ARCHITECTURE
	_ Dinh Nguyen <dinguyen at opensource.altera.com>

For SPEAR PLATFORM SUPPORT
	_ Viresh Kumar <vireshk at kernel.org>
	_ Shiraz Hashim <shiraz.linux.kernel at gmail.com>

For TEGRA ARCHITECTURE SUPPORT
	_ Stephen Warren <swarren at wwwdotorg.org>
	_ Thierry Reding <thierry.reding at gmail.com>
	_ Alexandre Courbot <gnurou at gmail.com> 

For ARM/Ux500 ARM ARCHITECTURE
	_ Linus Walleij <linus.walleij at linaro.org>

Patrice Chotard (8):
  mfd: stmpe: Add STMPE_IDX_SYS_CTRL/2 enum
  mfd: stmpe: Add reset support for all STMPE variant
  gpio: stmpe: fix edge and rising/falling edge detection
  gpio: stmpe: write int status register only when needed
  Documentation: dt: add stmpe1600 compatible string to stmpe mfd
  mfd: Add STMPE1600 support
  gpio: stmpe: Add STMPE1600 support
  gpio: stmpe: configure GPIO as output by default

 Documentation/devicetree/bindings/mfd/stmpe.txt |   2 +-
 drivers/gpio/gpio-stmpe.c                       | 142 ++++++++++++++++++------
 drivers/mfd/stmpe-i2c.c                         |   2 +
 drivers/mfd/stmpe.c                             | 105 ++++++++++++++----
 drivers/mfd/stmpe.h                             |  30 ++++-
 include/linux/mfd/stmpe.h                       |   3 +
 6 files changed, 223 insertions(+), 61 deletions(-)

-- 
1.9.1