[PATCH RFT 2/5] iio: mxs-lradc: move TS config into suitable function

[Jonathan Cameron]

On 14/04/16 21:01, Marek Vasut wrote:
> On 04/14/2016 05:48 PM, Stefan Wahren wrote:
>> This patch moves the touchscreen type configuration into
>> a more suitable function. Btw this simplifies PM ops later.
>>
>> Signed-off-by: Stefan Wahren <stefan.wahren at i2se.com>
> 
> Looks OK
> 
> Reviewed-by: Marek Vasut <marex at denx.de>
Please do CC Dmitry and linux-input on any patches 'touching' the
touchscreen parts of the driver.  I'm happy this one is simple
enough to apply anyway, but best to make sure everyone is in the
loop.

Something a little odd happened when applying the patch.  Automerging
failed so I did it by hand. Not sure what had changed!

Anyhow, please sanity check I haven't messed it up.

Applied to the togreg branch of iio.git - initially pushed out as
testing for the autobuilders to play with it.

Thanks,


Jonathan
> 
>> ---
>>  drivers/iio/adc/mxs-lradc.c |   21 +++++++++++----------
>>  1 file changed, 11 insertions(+), 10 deletions(-)
>>
>> diff --git a/drivers/iio/adc/mxs-lradc.c b/drivers/iio/adc/mxs-lradc.c
>> index 0576953..7118fca 100644
>> --- a/drivers/iio/adc/mxs-lradc.c
>> +++ b/drivers/iio/adc/mxs-lradc.c
>> @@ -686,6 +686,17 @@ static void mxs_lradc_prepare_pressure(struct mxs_lradc *lradc)
>>  
>>  static void mxs_lradc_enable_touch_detection(struct mxs_lradc *lradc)
>>  {
>> +	/* Configure the touchscreen type */
>> +	if (lradc->soc == IMX28_LRADC) {
>> +		mxs_lradc_reg_clear(lradc, LRADC_CTRL0_MX28_TOUCH_SCREEN_TYPE,
>> +				    LRADC_CTRL0);
>> +
>> +		if (lradc->use_touchscreen == MXS_LRADC_TOUCHSCREEN_5WIRE)
>> +			mxs_lradc_reg_set(lradc,
>> +					  LRADC_CTRL0_MX28_TOUCH_SCREEN_TYPE,
>> +					  LRADC_CTRL0);
>> +	}
>> +
>>  	mxs_lradc_setup_touch_detection(lradc);
>>  
>>  	lradc->cur_plate = LRADC_TOUCH;
>> @@ -1491,16 +1502,6 @@ static int mxs_lradc_hw_init(struct mxs_lradc *lradc)
>>  	mxs_lradc_reg_wrt(lradc, 0, LRADC_DELAY(2));
>>  	mxs_lradc_reg_wrt(lradc, 0, LRADC_DELAY(3));
>>  
>> -	/* Configure the touchscreen type */
>> -	if (lradc->soc == IMX28_LRADC) {
>> -		mxs_lradc_reg_clear(lradc, LRADC_CTRL0_MX28_TOUCH_SCREEN_TYPE,
>> -				    LRADC_CTRL0);
>> -
>> -	if (lradc->use_touchscreen == MXS_LRADC_TOUCHSCREEN_5WIRE)
>> -		mxs_lradc_reg_set(lradc, LRADC_CTRL0_MX28_TOUCH_SCREEN_TYPE,
>> -				  LRADC_CTRL0);
>> -	}
>> -
>>  	/* Start internal temperature sensing. */
>>  	mxs_lradc_reg_wrt(lradc, 0, LRADC_CTRL2);
>>  
>>
> 
>