[PATCH v2 8/8] ARM: dts: Add support of Bus frequency using VDD_INT for exynos5422-odroidxu3

[Chanwoo Choi]

This patch adds the bus device tree nodes for INT (Internal) block
to enable the AMBA bus frequency scaling and add the NoC (Network on Chip)
Probe Device Tree node to measure the bandwidht for AMBA AXI bus.

The WCORE bus bus is parent device in INT block using VDD_INT.

Signed-off-by: Chanwoo Choi <cw00.choi at samsung.com>
Tested-by: Markus Reichl <m.reichl at fivetechno.de>
Tested-by: Anand Moon <linux.amoon at gmail.com>
---
 arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi | 99 ++++++++++++++++++++++
 1 file changed, 99 insertions(+)

diff --git a/arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi b/arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi
index 1bd507bfa750..d32984c5ff93 100644
--- a/arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi
+++ b/arch/arm/boot/dts/exynos5422-odroidxu3-common.dtsi
@@ -56,6 +56,89 @@
 	};
 };
 
+&bus_wcore {
+	devfreq-events = <&nocp_mem0_0>, <&nocp_mem0_1>,
+			<&nocp_mem1_0>, <&nocp_mem1_1>;
+	vdd-supply = <&buck3_reg>;
+	exynos,saturation-ratio = <100>;
+	status = "okay";
+};
+
+&bus_noc {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_fsys_apb {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_fsys {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_fsys2 {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_mfc {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_gen {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_peri {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_g2d {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_g2d_acp {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_jpeg {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_jpeg_apb {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_disp1_fimd {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_disp1 {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_gscl_scaler {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
+&bus_mscl {
+	devfreq = <&bus_wcore>;
+	status = "okay";
+};
+
 &clock_audss {
 	assigned-clocks = <&clock_audss EXYNOS_MOUT_AUDSS>,
 			<&clock_audss EXYNOS_MOUT_I2S>,
@@ -361,6 +444,22 @@
 	cap-sd-highspeed;
 };
 
+&nocp_mem0_0 {
+	status = "okay";
+};
+
+&nocp_mem0_1 {
+	status = "okay";
+};
+
+&nocp_mem1_0 {
+	status = "okay";
+};
+
+&nocp_mem1_1 {
+	status = "okay";
+};
+
 &pinctrl_0 {
 	hdmi_hpd_irq: hdmi-hpd-irq {
 		samsung,pins = "gpx3-7";
-- 
1.9.1