[PATCH v2 11/13] ARM: dts: db600c: add i2c support

[Srinivas Kandagatla]

This patch adds nodes required to enable 4 i2c buses on the board which
are connected to various sensors and eeprom.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla at linaro.org>
---
 arch/arm/boot/dts/qcom-apq8064-arrow-db600c.dts | 46 +++++++++++++++++++++++++
 1 file changed, 46 insertions(+)

diff --git a/arch/arm/boot/dts/qcom-apq8064-arrow-db600c.dts b/arch/arm/boot/dts/qcom-apq8064-arrow-db600c.dts
index 8c18a4b..2f0dfff 100644
--- a/arch/arm/boot/dts/qcom-apq8064-arrow-db600c.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-arrow-db600c.dts
@@ -9,6 +9,10 @@
 	aliases {
 		serial0 = &gsbi7_serial;
 		serial1 = &gsbi1_serial;
+		i2c0 = &gsbi2_i2c;
+		i2c1 = &gsbi3_i2c;
+		i2c2 = &gsbi4_i2c;
+		i2c3 = &gsbi7_i2c;
 	};
 
 	regulators {
@@ -141,6 +145,42 @@
 			};
 		};
 
+		gsbi at 12480000 {
+			status = "okay";
+			qcom,mode = <GSBI_PROT_I2C>;
+			i2c at 124a0000 {
+				/* On Low speed expansion and Sensors */
+				label = "LS-I2C0";
+				status = "okay";
+			};
+		};
+
+		gsbi at 16200000 {
+			status = "okay";
+			qcom,mode = <GSBI_PROT_I2C>;
+			i2c at 16280000 {
+			/* On Low speed expansion */
+				status = "okay";
+				label = "LS-I2C1";
+				clock-frequency = <200000>;
+				eeprom at 52 {
+					compatible = "atmel,24c128";
+					reg = <0x52>;
+					pagesize = <64>;
+				};
+			};
+		};
+
+		gsbi at 16300000 {
+			status = "okay";
+			qcom,mode = <GSBI_PROT_I2C>;
+			i2c at 16380000 {
+				/* On High speed expansion */
+				label = "HS-CAM-I2C3";
+				status = "okay";
+			};
+		};
+
 		/* DEBUG UART  */
 		gsbi at 16600000 {
 			status = "okay";
@@ -151,6 +191,12 @@
 				pinctrl-names = "default";
 				pinctrl-0 = <&gsbi7_uart_2pins>;
 			};
+
+			i2c at 16680000 {
+				/* On High speed expansion */
+				status = "okay";
+				label = "HS-CAM-I2C2";
+			};
 		};
 
 		leds {
-- 
2.5.0