[PATCH] ARM: OMAP3: Fix imprecise external abort for off mode on 36xx

[Dave Gerlach]

On 04/11/2016 04:13 PM, Tony Lindgren wrote:
> * Dave Gerlach <d-gerlach at ti.com> [160411 11:21]:
>> Tony,
>> On 04/07/2016 06:16 PM, Tony Lindgren wrote:
>>> * Dave Gerlach <d-gerlach at ti.com> [160407 13:18]:
>>>>
>>>> I have a series to convert omap3 PM code to using generic SRAM driver but
>>>> when testing I see an external abort on BBXM off mode resume very similar to
>>>> this that seems to be timing related caused by using generic SRAM driver to
>>>> re-copy PM code rather than omap3_sram_restore_context.
>>>>
>>>> By tracing the resume path I believe the abort is caused by
>>>> omap3_intc_resume_idle in pm34xx.c, which writes to two registers in the
>>>> INTC. Removing this call makes the abort unreproducible in my experiments
>>>> and changing the writes to reads causes a bus lock, so I'm pretty confident
>>>> it's coming from this call attempting to write to an idled INTC.
>>>>
>>>> Advisory 1.106 in DM3730 Silicon Errata Document [1] describes an issue with
>>>> "MPU Leaves MSTANDBY State Before IDLEREQ of Interrupt Controller is
>>>> Released" which sounds like a very similar failure situation to what we are
>>>> seeing even though the timing of INTC access is a bit further from WFI exit
>>>> than it describes. Perhaps there are more conditions where it can occur.
>>>> Pushed my WIP branch for SRAM series that shows the same failure here [2].
>>>
>>> Interesting, I think you may have something with the errata 1.106.. And
>>> looks like we also need still errata 1.62 handled also on 36xx in the
>>> same pdf. And need to disable intc autoidle early at least for HS omaps
>>> as save_secure_ram context supposedly also can do WFI.
>>>
>>> Maybe something like the following would make sense? It seems to work
>>> here without external aborts with your test branch on dm3730, and boots
>>> fine on omap3430 hs (n900).
>>>
>>> Or do you have some better ideas for a fix?
>>
>> I can also confirm that this fixes the external abort, I can not cause it
>> with your attached patch.
> 
> OK. I still can't quite see why exactly this patch fixes things. So
> I'm afraid it might be just hiding the problem..

I agree, moving the omap3_intc_resume_idle may just be masking the issue for
that exact situation, but I think we can get rid of it for off mode...

> 
>> I would be ok with the solution you have proposed and I was unable to come
>> up with anything better while trying to debug the issue originally.
>>
>> We still need the call to omap3_intc_resume_idle because the intc restore
>> context only gets called on resume from off mode. Perhaps we only need to
>> call omap3_intc_resume_idle when coming back from non-off modes, otherwise
>> let the context restore handle the reconfig of the INTC idle/sysconfig
>> registers?
> 
> OK. Did you actually test by commenting out omap3_intc_resume_idle()?
> 
> Yeah sounds like we can optimize out the restore there for non-off
> modes.

Yes I removed it entirely for testing, and I also tried something like this for
a possible workable solution (without your patch applied):

diff --git a/arch/arm/mach-omap2/pm34xx.c b/arch/arm/mach-omap2/pm34xx.c
index fcf975eb5e9d..8d39b44ba3a3 100644
--- a/arch/arm/mach-omap2/pm34xx.c
+++ b/arch/arm/mach-omap2/pm34xx.c
@@ -268,7 +268,6 @@ void omap_sram_idle(void)
        int per_next_state = PWRDM_POWER_ON;
        int core_next_state = PWRDM_POWER_ON;
        int per_going_off;
-       int core_prev_state;
        u32 sdrc_pwr = 0;

        mpu_next_state = pwrdm_read_next_pwrst(mpu_pwrdm);
@@ -348,17 +347,16 @@ void omap_sram_idle(void)
                sdrc_write_reg(sdrc_pwr, SDRC_POWER);

        /* CORE */
-       if (core_next_state < PWRDM_POWER_ON) {
-               core_prev_state = pwrdm_read_prev_pwrst(core_pwrdm);
-               if (core_prev_state == PWRDM_POWER_OFF) {
+       if (core_next_state < PWRDM_POWER_ON &&
+           pwrdm_read_prev_pwrst(core_pwrdm) == PWRDM_POWER_OFF) {
                        omap3_core_restore_context();
                        omap3_cm_restore_context();
                        omap3_push_sram_idle();
                        omap3_push_sram_secure_idle();
                        omap2_sms_restore_context();
-               }
-       }
-       omap3_intc_resume_idle();
+       } else
+               omap3_intc_resume_idle();
+

        pwrdm_post_transition(NULL);


Regards,
Dave


> 
> Tony
>