[PATCH v2] ARM: dts: orion5x: add device tree for kurobox-pro

[Gregory CLEMENT]

Hi Roger,
 
 On lun., avril 04 2016, Andrew Lunn <andrew at lunn.ch> wrote:

> On Wed, Mar 30, 2016 at 01:11:45AM +0900, Roger Shimizu wrote:
>> Add dts file to support Buffalo/Revogear Kurobox-Pro, which is marvell
>> orion5x based 3.5" HDD NAS.
>> 
>> It's a quite old product and already discontinued. So there's no
>> official website for it. But it was an early product which used marvell
>> orion5x 88F5182 chipset, it's popular in the community.
>> Some unofficial site:
>>   - http://buffalo.nas-central.org/wiki/Category:KuroboxPro
>>   - http://nice.kaze.com/KUROPRO_ProductSpecifications.pdf
>> 
>> This device tree is based on the board file:
>>   arch/arm/mach-orion5x/kurobox_pro-setup.c
>> However, the probing order of NAND and JEDEC-Flash are different from
>> the original board file, this results in incompatible minor number
>> for a few /dev/mtdX and /dev/mtdblockX devices.
>> So I still want to keep the board file for the time being.
>> 
>> Signed-off-by: Roger Shimizu <rogershimizu at gmail.com>
>
> Hi Roger
>
> Looks good:
>
> Reviewed-by: Andrew Lunn <andrew at lunn.ch>


Applied on mvebu/dt

Thanks,

Gregory


>
> 	     Andrew

-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com