[PATCH 2/2] clk: bcm2835: Fix PLL poweron

[Eric Anholt]

In poweroff, we set the reset bit and the power down bit, but only
managed to unset the reset bit for poweron.  This meant that if HDMI
did -EPROBE_DEFER after it had grabbed its clocks, we'd power down the
PLLH (that had been on at boot time) and never recover.

Signed-off-by: Eric Anholt <eric at anholt.net>
Cc: stable at vger.kernel.org
---
 drivers/clk/bcm/clk-bcm2835.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/clk/bcm/clk-bcm2835.c b/drivers/clk/bcm/clk-bcm2835.c
index 87616de..7a79708 100644
--- a/drivers/clk/bcm/clk-bcm2835.c
+++ b/drivers/clk/bcm/clk-bcm2835.c
@@ -554,6 +554,10 @@ static int bcm2835_pll_on(struct clk_hw *hw)
 	const struct bcm2835_pll_data *data = pll->data;
 	ktime_t timeout;
 
+	cprman_write(cprman, data->a2w_ctrl_reg,
+		     cprman_read(cprman, data->a2w_ctrl_reg) &
+		     ~A2W_PLL_CTRL_PWRDN);
+
 	/* Take the PLL out of reset. */
 	cprman_write(cprman, data->cm_ctrl_reg,
 		     cprman_read(cprman, data->cm_ctrl_reg) & ~CM_PLL_ANARST);
-- 
2.7.0