[PATCH 0/4] memory: pl17x: add support of PL175 and PL176 controllers

[Vladimir Zapolskiy]

Hi Joachim,

On 29.09.2015 23:39, Joachim Eastwood wrote:
> Hi Vladimir,
> 
> On 28 September 2015 at 18:50, Vladimir Zapolskiy <vz at mleia.com> wrote:
>> The change adds support of ARM PrimeCell PL175 MPMC and PL176 MPMC,
>> the static memory controllers on devices are similar to one found on
>> ARM PrimeCell PL172, add support to the existing driver.
>>
>> Vladimir Zapolskiy (4):
>>   memory: pl172: correct MPMC peripheral ID register bits
>>   memory: pl172: add ARM PrimeCell PL175 MPMC support
>>   memory: pl172: add ARM PrimeCell PL176 MPMC support
>>   doc: dt: arm,pl172: add description of PL175 and PL176 controllers
> 
> Changes look good to me.
> 
> What LPC32xx board did you test this on, btw?

I tested PL175 on Timll Devkit3250 board with 4Mb NOR.

> Also if you have added the controller to lpc32xx.dtsi it would be
> great if you could also submit those changes to the lpc32xx
> maintainer.
> 

Right, this is in my plans. To avoid any mess in the controller driver,
mach-lpc32xx must be converted to common clock framework firstly, that's
what I'm doing at the moment, then I'll send the corresponding EMC
updates in lpc32xx.dtsi.

By the way I've tested your clocksource driver on LPC32xx and it works
fine, but again clean switching to it is not possible until LPC32xx
clocks are out of the common clock framework.

--
With best wishes,
Vladimir