[linux-sunxi] [PATCH 0/2] ASoC: Add support for the Allwinner A10 codec

[Hans de Goede]

Hi,

On 09/28/2015 09:42 AM, Maxime Ripard wrote:
> Hi Priit,
>
> On Tue, Sep 22, 2015 at 04:26:57PM +0300, Priit Laes wrote:
>> On Sat, 2015-09-12 at 15:26 +0200, Maxime Ripard wrote:
>>> Hi everyone,
>>>
>>> This patch set adds the support for what Allwinner calls the codec on
>>> their SoCs.
>>>
>>> This codec is actually a combination of a codec and DAI, tied
>>> together
>>> in a single memory-mapped IP. It is completely standalone, and
>>> outputs
>>> directly the analog signal.
>>>
>>> While it supports both playback and capture, the capture is not
>>> implemented in this patch, and will be posted eventually as a
>>> separate
>>> one.
>>>
>>> This set, in order to be functional, has a dependency on the audio
>>> clocks patch set posted separately. However, it doesn't needs this to
>>> compile properly, so I guess it can be merged without really caring
>>> for the merging status of the clock patches.
>>
>> It works on Gemei G9 tablet which has also extra chip that
>> automatically switches output over from internal speakers to headphones
>> when connector is inserted.
>>
>> Now I noticed some weird things:
>>
>> When I have all the switches as ON in alsamixer, and I start disabling
>> them, I get following weird results.
>>
>> Left Mixer Left - LML
>> Right Mixer Left - LMR
>> Right Mixer Right - RMR
>>
>> Very faint output:
>> LML - ON
>> RML - Mute
>> RMR - ON
>>
>> Output works fully:
>> LML - Mute
>> RML - Mute
>> RMR - Mute
>>
>> When I Mute Pre-Amplifier and fiddle any of LML, RML or RMR, the output
>> stays mute even after setting Pre-Amplifier Mute back on:
>>
>> 1. All switches on
>> 2. Mute pre-amplifier
>> 3. Mute RMR
>> 4. Pre-Amilifier Mute Off
>> .. Music stays off
>> 5. Toggle Pre-Amplifier twice - output turns on
>
> Unfortunately, I don't have access to that SoC or that setup.

I'm seeing similar stuff on a cubieboard, both A10 and A20
based cubieboards, I have to fiddle a bit with the switches
to get things to work. At boot all switches are disabled.

On both A10 and A20 I need to enable to following for things to work:

unmute Pre-Amplifier DAC
unmute Pre-Amplifier Mute

I guess this is just a question if adding some mixer defaults to
the alsa userspace somewhere ?

Regards,

Hans