[PATCH v6 5/5] leds: netxbig: set led_classdev max_brightness

[Jacek Anaszewski]

On 09/28/2015 01:50 PM, Simon Guinot wrote:
> On Mon, Sep 28, 2015 at 12:15:22PM +0200, Jacek Anaszewski wrote:
>> On 09/28/2015 11:19 AM, Simon Guinot wrote:
>>> On Mon, Sep 28, 2015 at 10:02:35AM +0200, Jacek Anaszewski wrote:
>>>> Hi Simon,
>>>
>>> Hi Jacek,
>>>
>>>>
>>>> Does your device support reading the brightness currently set?
>>>
>>> No it don't.
>>>
>>>> If so, it would be good to implement brightness_get op, because
>>>> AFAIR you mentioned that the firmware you are working with sets
>>>> always maximum brightness value. Having the op implemented would
>>>> allow to find this out.
>>>
>>> I don't understand how this can help. I mean, the only issue is that at
>>> startup the initial LED state is unknown. And the software brightness
>>> value could be false. But once the LED is configured, the brightness
>>> values for software and hardware are synchronized. The brightness value
>>> is stored/cached in led_classdev and it can be retrieved by the user via
>>> sysfs...
>>>
>>> For my own knowledge, is there some interest in having brightness_get(),
>>> aside of guessing the LED initial state ?
>>
>> Some LED controllers can adjust brightness in case battery voltage level
>> falls below some threshold.
>
> OK, thanks for the explanation.
>
>>
>>> What does the embedded firmware is writing 255 or 0 into the brightness
>>> sysfs attribute. The max_brightness value is ignored. After this patch,
>>> writing 255 and 0 still allows to configure the LED in the same way:
>>> maximum brightness or off. Thus, I believe there is no compatibility
>>> issue.
>>
>> LED core always assures that brightness value passed to brightness_set
>> op does not exceed max_brightness value. So, now after executing
>> "echo 255 > brightness", LED core will adjust it to max_brightness
>> (e.g. 7) before passing to brightness_set.
>>
>> In the message [1], you mentioned that "LEDs are only enabled at their
>> maximum level", so IIUC following is possible:
>>
>> #echo 3 > "brightness"
>>
>> firmware sets brightness to max_brightness from DT (e.g. 7), but
>>
>> #cat brightness
>> #3
>>
>> Is it true?
>
> Oh no sorry, it is a misunderstanding. By "LEDs are only enabled at
> their maximum level", I was meaning "LEDs are only enabled at their
> maximum level by the LaCie stock firmware". The firmware don't make
> use of the different hardware brightness levels available. But the
> feature works perfectly. If you write 3 into sysfs "brightness", then
> you get the third brightness level.

I thought that driver talks to firmware, which controls the LEDs.
 From your explanation I infer that this driver replaces LaCie stock
firmware, am I right? There must be however some circuit that controls
LED brightness then.

> OK, I understand you remark now. Sorry for not being very clear in a
> first place.


-- 
Best Regards,
Jacek Anaszewski