[PATCH RESEND v3 6/9] net: fix phy refcounting in a bunch of drivers

Russell King rmk+kernel at arm.linux.org.uk
Thu Sep 24 12:36:18 PDT 2015


of_phy_find_device() increments the phy struct device refcount, which
we need to properly balance.  Add code to network drivers using this
function to ensure that the struct device refcount is correctly
balanced.

For xgene, looking back in the history, we should be able to use
of_phy_connect() with a zero flags argument for the DT case as this is
how the driver used to operate prior to de7b5b3d790a ("net: eth: xgene:
change APM X-Gene SoC platform ethernet to support ACPI").

This leaves the Cavium Thunder BGX unfixed; fixing this driver is a
complicated task, one which the maintainers need to be involved with.

Signed-off-by: Russell King <rmk+kernel at arm.linux.org.uk>
---
 drivers/net/ethernet/apm/xgene/xgene_enet_hw.c | 24 ++++++++++++++++--------
 drivers/net/ethernet/freescale/gianfar.c       |  3 +++
 drivers/net/ethernet/freescale/ucc_geth.c      |  8 +++++++-
 drivers/net/ethernet/marvell/mvneta.c          |  2 ++
 drivers/net/ethernet/xilinx/xilinx_emaclite.c  |  2 ++
 5 files changed, 30 insertions(+), 9 deletions(-)

diff --git a/drivers/net/ethernet/apm/xgene/xgene_enet_hw.c b/drivers/net/ethernet/apm/xgene/xgene_enet_hw.c
index cfa37041ab71..c4bb8027b3fb 100644
--- a/drivers/net/ethernet/apm/xgene/xgene_enet_hw.c
+++ b/drivers/net/ethernet/apm/xgene/xgene_enet_hw.c
@@ -689,16 +689,24 @@ static int xgene_enet_phy_connect(struct net_device *ndev)
 			netdev_dbg(ndev, "No phy-handle found in DT\n");
 			return -ENODEV;
 		}
-		pdata->phy_dev = of_phy_find_device(phy_np);
-	}
 
-	phy_dev = pdata->phy_dev;
+		phy_dev = of_phy_connect(ndev, phy_np, &xgene_enet_adjust_link,
+					 0, pdata->phy_mode);
+		if (!phy_dev) {
+			netdev_err(ndev, "Could not connect to PHY\n");
+			return -ENODEV;
+		}
+
+		pdata->phy_dev = phy_dev;
+	} else {
+		phy_dev = pdata->phy_dev;
 
-	if (!phy_dev ||
-	    phy_connect_direct(ndev, phy_dev, &xgene_enet_adjust_link,
-			       pdata->phy_mode)) {
-		netdev_err(ndev, "Could not connect to PHY\n");
-		return  -ENODEV;
+		if (!phy_dev ||
+		    phy_connect_direct(ndev, phy_dev, &xgene_enet_adjust_link,
+				       pdata->phy_mode)) {
+			netdev_err(ndev, "Could not connect to PHY\n");
+			return  -ENODEV;
+		}
 	}
 
 	pdata->phy_speed = SPEED_UNKNOWN;
diff --git a/drivers/net/ethernet/freescale/gianfar.c b/drivers/net/ethernet/freescale/gianfar.c
index 4b69d061d90f..65a16086faec 100644
--- a/drivers/net/ethernet/freescale/gianfar.c
+++ b/drivers/net/ethernet/freescale/gianfar.c
@@ -1702,6 +1702,7 @@ static void gfar_configure_serdes(struct net_device *dev)
 	tbiphy = of_phy_find_device(priv->tbi_node);
 	if (!tbiphy) {
 		dev_err(&dev->dev, "error: Could not get TBI device\n");
+		put_device(&tbiphy->dev);
 		return;
 	}
 
@@ -1723,6 +1724,8 @@ static void gfar_configure_serdes(struct net_device *dev)
 	phy_write(tbiphy, MII_BMCR,
 		  BMCR_ANENABLE | BMCR_ANRESTART | BMCR_FULLDPLX |
 		  BMCR_SPEED1000);
+
+	put_device(&tbiphy->dev);
 }
 
 static int __gfar_is_rx_idle(struct gfar_private *priv)
diff --git a/drivers/net/ethernet/freescale/ucc_geth.c b/drivers/net/ethernet/freescale/ucc_geth.c
index 4dd40e057f40..650f7888e32b 100644
--- a/drivers/net/ethernet/freescale/ucc_geth.c
+++ b/drivers/net/ethernet/freescale/ucc_geth.c
@@ -1384,6 +1384,8 @@ static int adjust_enet_interface(struct ucc_geth_private *ugeth)
 		value = phy_read(tbiphy, ENET_TBI_MII_CR);
 		value &= ~0x1000;	/* Turn off autonegotiation */
 		phy_write(tbiphy, ENET_TBI_MII_CR, value);
+
+		put_device(&tbiphy->dev);
 	}
 
 	init_check_frame_length_mode(ug_info->lengthCheckRx, &ug_regs->maccfg2);
@@ -1702,8 +1704,10 @@ static void uec_configure_serdes(struct net_device *dev)
 	 * everything for us?  Resetting it takes the link down and requires
 	 * several seconds for it to come back.
 	 */
-	if (phy_read(tbiphy, ENET_TBI_MII_SR) & TBISR_LSTATUS)
+	if (phy_read(tbiphy, ENET_TBI_MII_SR) & TBISR_LSTATUS) {
+		put_device(&tbiphy->dev);
 		return;
+	}
 
 	/* Single clk mode, mii mode off(for serdes communication) */
 	phy_write(tbiphy, ENET_TBI_MII_ANA, TBIANA_SETTINGS);
@@ -1711,6 +1715,8 @@ static void uec_configure_serdes(struct net_device *dev)
 	phy_write(tbiphy, ENET_TBI_MII_TBICON, TBICON_CLK_SELECT);
 
 	phy_write(tbiphy, ENET_TBI_MII_CR, TBICR_SETTINGS);
+
+	put_device(&tbiphy->dev);
 }
 
 /* Configure the PHY for dev.
diff --git a/drivers/net/ethernet/marvell/mvneta.c b/drivers/net/ethernet/marvell/mvneta.c
index fe2299ac4f5c..0dce037a2682 100644
--- a/drivers/net/ethernet/marvell/mvneta.c
+++ b/drivers/net/ethernet/marvell/mvneta.c
@@ -3173,6 +3173,8 @@ static int mvneta_probe(struct platform_device *pdev)
 		struct phy_device *phy = of_phy_find_device(dn);
 
 		mvneta_fixed_link_update(pp, phy);
+
+		put_device(&phy->dev);
 	}
 
 	return 0;
diff --git a/drivers/net/ethernet/xilinx/xilinx_emaclite.c b/drivers/net/ethernet/xilinx/xilinx_emaclite.c
index 6008eee01a33..cf468c87ce57 100644
--- a/drivers/net/ethernet/xilinx/xilinx_emaclite.c
+++ b/drivers/net/ethernet/xilinx/xilinx_emaclite.c
@@ -828,6 +828,8 @@ static int xemaclite_mdio_setup(struct net_local *lp, struct device *dev)
 		if (!phydev)
 			dev_info(dev,
 				 "MDIO of the phy is not registered yet\n");
+		else
+			put_device(&phydev->dev);
 		return 0;
 	}
 
-- 
2.1.0




More information about the linux-arm-kernel mailing list