[PATCH 2/2] Convert smsc911x to use ACPI as well as DT

[Sudeep Holla]

On 23/09/15 18:22, Jeremy Linton wrote:
> Marc,
>
> |FWIW, mainline booting with this patch on Juno r1 with ACPI enabled
> dies a |horrible death:
>
> Sorry about the delay, I didn't see this message.
>
> <trimmed>
>
> |How did you get this to work? Firmware release?
>
> Yes, it's a firmware problem with the ACPI tables. It is likely you
> need _DSD changes for the SMSC. If your trying to run juno with ACPI
> there are a few other ACPI table changes you will need beyond what
> was in the last linaro release. I wanted to just provide a direct
> link to the correct firmware in this response, but it seems the
> required version is sort of up in the air at the moment. Be assured I
> will really push on this next week, and will provide a follow up
> here.
>
> Originally, the lack of DSD wasn't a problem, but as this patch
> evolved  the fact that it consolidates a number of configuration code
> paths balancing that got tricky, and ACPI machines with "bad" tables
> were the victims (rather than breaking something I can't control).
>

Even now absence of _DSD *should* continue to be just fine. We can
bailout without initializing the device. Pulling the entire kernel down
just because of an incomplete device entry make no sense IMO.

> In the meantime, if this is blocking anyone I can provide
> instructions on how to update the required ACPI tables.
>

I found that the driver has issues even with DT missing some of the
optional properties. We need to fix it but I don't have much knowledge
of the driver and also not sure how these properties are defined in
ACPI/DSD world i.e. required vs optional.

Regards,
Sudeep