[PATCH 2/5] ARM: dts: DRA72x: Add IPC sub-mailbox nodes for IPU1, IPU2 & DSP1

[Suman Anna]

Add the sub-mailbox nodes that are used to communicate between
MPU and the remote processors IPU1, IPU2 and DSP1. These match the
respective node definitions on DRA74x to maintain compatibility for
the equivalent remote processors. There is no DSP2 on DRA72x, and
so the corresponding sub-mailbox node is not added.

These sub-mailbox nodes are added to match the hard-coded mailbox
configuration used within the TI IPC 3.x software package. The
Dual-Cortex M4 IPU1 and IPU2 processor sub-systems are assumed to
be running in SMP-mode, and hence only a single sub-mailbox node
is added for each.

All these sub-mailbox nodes are left in disabled state, and should
be enabled (and modified if needed) as per the individual product
configuration in the corresponding board dts files.

Signed-off-by: Suman Anna <s-anna at ti.com>
---
 arch/arm/boot/dts/dra72x.dtsi | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/arch/arm/boot/dts/dra72x.dtsi b/arch/arm/boot/dts/dra72x.dtsi
index eaca143faa77..70a217050a4c 100644
--- a/arch/arm/boot/dts/dra72x.dtsi
+++ b/arch/arm/boot/dts/dra72x.dtsi
@@ -45,3 +45,24 @@
 		 <&dss_video1_clk>;
 	clock-names = "fck", "video1_clk";
 };
+
+&mailbox5 {
+	mbox_ipu1_ipc3x: mbox_ipu1_ipc3x {
+		ti,mbox-tx = <6 2 2>;
+		ti,mbox-rx = <4 2 2>;
+		status = "disabled";
+	};
+	mbox_dsp1_ipc3x: mbox_dsp1_ipc3x {
+		ti,mbox-tx = <5 2 2>;
+		ti,mbox-rx = <1 2 2>;
+		status = "disabled";
+	};
+};
+
+&mailbox6 {
+	mbox_ipu2_ipc3x: mbox_ipu2_ipc3x {
+		ti,mbox-tx = <6 2 2>;
+		ti,mbox-rx = <4 2 2>;
+		status = "disabled";
+	};
+};
-- 
2.5.0