[PATCH 5/6] ARM: dts: sun6i: Add support for Sinlinx A31s SDK board

[Chen-Yu Tsai]

On Wed, Sep 16, 2015 at 2:20 PM, Maxime Ripard
<maxime.ripard at free-electrons.com> wrote:
> On Mon, Sep 14, 2015 at 03:24:47PM +0800, Chen-Yu Tsai wrote:
>> On Fri, Aug 28, 2015 at 8:34 PM, Maxime Ripard
>> <maxime.ripard at free-electrons.com> wrote:
>> > On Fri, Aug 28, 2015 at 05:54:38PM +0800, Chen-Yu Tsai wrote:
>> >> The Sinlinx A31s SDK is a A31s based module/baseboard development kit.
>> >>
>> >> The core module has the SoC, PMIC, DRAM, eMMC and supporting components.
>> >> There are also pads for UART0, JTAG and I2S.
>> >
>> > Can you use that core module without that baseboard?
>>
>> You could just solder 5v, gnd, and uart, and it should work.
>> Not that I actually tried it.
>>
>> >> The baseboard has 100 Mbps Ethernet, 5x USB 2.0 host ports via a USB 2.0
>> >> hub chip, MMC, HDMI, SPDIF, CIR, audio jacks, 2 tablet-like volume
>> >> buttons, RS232 style UART and USB OTG (though VBUS is not connected).
>> >> Various headers are available for other addon modules, such as SDIO
>> >> WiFi, LCD display, camera sensor, UARTs, I2C, SPI and GPIOs.
>> >
>> > Can the baseboard be used with our core modules?
>>
>> Doubtful. The baseboard is more like a demonstration platform for the
>> core board.
>>
>> What do you suggest?
>
> Nothing then, I was just trying to understand the possible
> combinations, but it looks like there's none :)

OK then. I'll fix up the gpu regulator stuff, and resend the series sans
the primo81 patch after the axp221 supply renaming patches are merged.

The primo81 LCD and backlight need some more work. No PWM and SSD2825
MIPI bridge support in the kernel yet.


Regards,
ChenYu