[PATCH v4 14/16] drm: bridge: analogix/dp: try force hpd after plug in lookup failed
Rob Herring
robherring2 at gmail.com
Wed Sep 2 13:17:57 PDT 2015
On Tue, Sep 1, 2015 at 1:14 AM, Yakir Yang <ykk at rock-chips.com> wrote:
> Some edp screen do not have hpd signal, so we can't just return
> failed when hpd plug in detect failed.
This is a property of the panel (or connector perhaps), so this
property should be located there. At least, it is a common issue and
not specific to this chip. We could have an HDMI connector and failed
to hook up HPD for example. A connector node is also where hpd-gpios
should be located instead (and are already defined by
../bindings/video/hdmi-connector.txt). Perhaps we need a eDP connector
binding, too.
Are there any eDP panels which don't have EDID and need panel details in DT?
Rob
> This is an hardware property, so we need add a devicetree property
> "analogix,need-force-hpd" to indicate this sutiation.
>
> Signed-off-by: Yakir Yang <ykk at rock-chips.com>
> ---
> Changes in v4: None
> Changes in v3:
> - Add "analogix,need-force-hpd" to indicate whether driver need foce
> hpd when hpd detect failed.
>
> Changes in v2: None
>
> .../devicetree/bindings/drm/bridge/analogix_dp.txt | 4 ++-
> .../bindings/video/analogix_dp-rockchip.txt | 1 +
> .../devicetree/bindings/video/exynos_dp.txt | 1 +
> drivers/gpu/drm/bridge/analogix/analogix_dp_core.c | 36 +++++++++++++++++++---
> drivers/gpu/drm/bridge/analogix/analogix_dp_core.h | 2 ++
> drivers/gpu/drm/bridge/analogix/analogix_dp_reg.c | 9 ++++++
> 6 files changed, 47 insertions(+), 6 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/drm/bridge/analogix_dp.txt b/Documentation/devicetree/bindings/drm/bridge/analogix_dp.txt
> index f54dc3e..c310367 100644
> --- a/Documentation/devicetree/bindings/drm/bridge/analogix_dp.txt
> +++ b/Documentation/devicetree/bindings/drm/bridge/analogix_dp.txt
> @@ -22,6 +22,9 @@ Required properties for dp-controller:
> from general PHY binding: Should be "dp".
>
> Optional properties for dp-controller:
> + -analogix,need-force-hpd:
> + Indicate driver need force hpd when hpd detect failed, this
> + is used for some eDP screen which don't have hpd signal.
> -hpd-gpios:
> Hotplug detect GPIO.
> Indicates which GPIO should be used for hotplug detection
> @@ -31,7 +34,6 @@ Optional properties for dp-controller:
> * Documentation/devicetree/bindings/video/exynos_dp.txt
> * Documentation/devicetree/bindings/video/analogix_dp-rockchip.txt
>
> -
> [1]: Documentation/devicetree/bindings/media/video-interfaces.txt
> -------------------------------------------------------------------------------
>
> diff --git a/Documentation/devicetree/bindings/video/analogix_dp-rockchip.txt b/Documentation/devicetree/bindings/video/analogix_dp-rockchip.txt
> index 502483e..8b9ed7d 100644
> --- a/Documentation/devicetree/bindings/video/analogix_dp-rockchip.txt
> +++ b/Documentation/devicetree/bindings/video/analogix_dp-rockchip.txt
> @@ -28,6 +28,7 @@ For the below properties, please refer to Analogix DP binding document:
> - phys (required)
> - phy-names (required)
> - hpd-gpios (optional)
> +- analogix,need-force-hpd (optional)
> -------------------------------------------------------------------------------
>
> Example:
> diff --git a/Documentation/devicetree/bindings/video/exynos_dp.txt b/Documentation/devicetree/bindings/video/exynos_dp.txt
> index ea03b3a..4f06e80 100644
> --- a/Documentation/devicetree/bindings/video/exynos_dp.txt
> +++ b/Documentation/devicetree/bindings/video/exynos_dp.txt
> @@ -41,6 +41,7 @@ For the below properties, please refer to Analogix DP binding document:
> -phys (required)
> -phy-names (required)
> -hpd-gpios (optional)
> + -analogix,need-force-hpd (optional)
> -video interfaces (optional)
>
> Deprecated properties for DisplayPort:
> diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
> index f7227ec..e6b328a 100644
> --- a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
> +++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
> @@ -63,15 +63,38 @@ static int analogix_dp_detect_hpd(struct analogix_dp_device *dp)
> {
> int timeout_loop = 0;
>
> - while (analogix_dp_get_plug_in_status(dp) != 0) {
> + while (timeout_loop < DP_TIMEOUT_LOOP_COUNT) {
> + if (analogix_dp_get_plug_in_status(dp) == 0)
> + return 0;
> +
> timeout_loop++;
> - if (DP_TIMEOUT_LOOP_COUNT < timeout_loop) {
> - dev_err(dp->dev, "failed to get hpd plug status\n");
> - return -ETIMEDOUT;
> - }
> usleep_range(10, 11);
> }
>
> + /*
> + * Some edp screen do not have hpd signal, so we can't just
> + * return failed when hpd plug in detect failed, DT property
> + * "need-force-hpd" would indicate whether driver need this.
> + */
> + if (!dp->need_force_hpd)
> + return -ETIMEDOUT;
> +
> + /*
> + * The eDP TRM indicate that if HPD_STATUS(RO) is 0, AUX CH
> + * will not work, so we need to give a force hpd action to
> + * set HPD_STATUS manually.
> + */
> + dev_dbg(dp->dev, "failed to get hpd plug status, try to force hpd\n");
> +
> + analogix_dp_force_hpd(dp);
> +
> + if (analogix_dp_get_plug_in_status(dp) != 0) {
> + dev_err(dp->dev, "failed to get hpd plug in status\n");
> + return -EINVAL;
> + }
> +
> + dev_dbg(dp->dev, "success to get plug in status after force hpd\n");
> +
> return 0;
> }
>
> @@ -1287,6 +1310,9 @@ int analogix_dp_bind(struct device *dev, struct drm_device *drm_dev,
> if (IS_ERR(dp->reg_base))
> return PTR_ERR(dp->reg_base);
>
> + dp->need_force_hpd =
> + of_property_read_bool(dev->of_node, "analogix,need-force-hpd");
> +
> dp->hpd_gpio = of_get_named_gpio(dev->of_node, "hpd-gpios", 0);
> if (gpio_is_valid(dp->hpd_gpio))
> dp->hpd_gpio = of_get_named_gpio(dev->of_node,
> diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.h b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.h
> index d8945e2..6960ab3 100644
> --- a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.h
> +++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.h
> @@ -160,6 +160,7 @@ struct analogix_dp_device {
> struct phy *phy;
> int dpms_mode;
> int hpd_gpio;
> + bool need_force_hpd;
>
> struct analogix_dp_plat_data *plat_data;
> };
> @@ -180,6 +181,7 @@ void analogix_dp_set_analog_power_down(struct analogix_dp_device *dp,
> bool enable);
> void analogix_dp_init_analog_func(struct analogix_dp_device *dp);
> void analogix_dp_init_hpd(struct analogix_dp_device *dp);
> +void analogix_dp_force_hpd(struct analogix_dp_device *dp);
> enum dp_irq_type analogix_dp_get_irq_type(struct analogix_dp_device *dp);
> void analogix_dp_clear_hotplug_interrupts(struct analogix_dp_device *dp);
> void analogix_dp_reset_aux(struct analogix_dp_device *dp);
> diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_reg.c b/drivers/gpu/drm/bridge/analogix/analogix_dp_reg.c
> index 15346fe..3086afc 100644
> --- a/drivers/gpu/drm/bridge/analogix/analogix_dp_reg.c
> +++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_reg.c
> @@ -365,6 +365,15 @@ void analogix_dp_init_hpd(struct analogix_dp_device *dp)
> writel(reg, dp->reg_base + ANALOGIX_DP_SYS_CTL_3);
> }
>
> +void analogix_dp_force_hpd(struct analogix_dp_device *dp)
> +{
> + u32 reg;
> +
> + reg = readl(dp->reg_base + ANALOGIX_DP_SYS_CTL_3);
> + reg = (F_HPD | HPD_CTRL);
> + writel(reg, dp->reg_base + ANALOGIX_DP_SYS_CTL_3);
> +}
> +
> enum dp_irq_type analogix_dp_get_irq_type(struct analogix_dp_device *dp)
> {
> u32 reg;
> --
> 2.1.2
>
>
More information about the linux-arm-kernel
mailing list