[PATCH 1/2] mmc: sdhci-pxav3: Fix tabbing issue
Vaibhav Hiremath
vaibhav.hiremath at linaro.org
Tue Sep 1 12:24:13 PDT 2015
There were some coding style issues where spaces have been used instead
of tabs, for example, in macro definitions, alignment of function
declarations/definitions, etc...
This patch fixes all such occurrences in the code.
And also use BIT for bit definitions.
Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath at linaro.org>
---
drivers/mmc/host/sdhci-pxav3.c | 63 ++++++++++++++++++++++--------------------
1 file changed, 33 insertions(+), 30 deletions(-)
diff --git a/drivers/mmc/host/sdhci-pxav3.c b/drivers/mmc/host/sdhci-pxav3.c
index 946d37f..d02bc37 100644
--- a/drivers/mmc/host/sdhci-pxav3.c
+++ b/drivers/mmc/host/sdhci-pxav3.c
@@ -39,24 +39,29 @@
#include "sdhci.h"
#include "sdhci-pltfm.h"
-#define PXAV3_RPM_DELAY_MS 50
+#define PXAV3_RPM_DELAY_MS 50
-#define SD_CLOCK_BURST_SIZE_SETUP 0x10A
-#define SDCLK_SEL 0x100
-#define SDCLK_DELAY_SHIFT 9
-#define SDCLK_DELAY_MASK 0x1f
+#define SD_CLOCK_BURST_SIZE_SETUP 0x10A
+#define SDCLK_SEL 0x100
+#define SDCLK_DELAY_SHIFT 9
+#define SDCLK_DELAY_MASK 0x1f
-#define SD_CFG_FIFO_PARAM 0x100
-#define SDCFG_GEN_PAD_CLK_ON (1<<6)
-#define SDCFG_GEN_PAD_CLK_CNT_MASK 0xFF
-#define SDCFG_GEN_PAD_CLK_CNT_SHIFT 24
+#define SD_CFG_FIFO_PARAM 0x100
+#define SDCFG_GEN_PAD_CLK_ON BIT(6)
+#define SDCFG_GEN_PAD_CLK_CNT_MASK 0xFF
+#define SDCFG_GEN_PAD_CLK_CNT_SHIFT 24
-#define SD_SPI_MODE 0x108
-#define SD_CE_ATA_1 0x10C
+#define SD_SPI_MODE 0x108
+#define SD_CE_ATA_1 0x10C
-#define SD_CE_ATA_2 0x10E
-#define SDCE_MISC_INT (1<<2)
-#define SDCE_MISC_INT_EN (1<<1)
+#define SD_CE_ATA_2 0x10E
+#define SDCE_MISC_INT BIT(2)
+#define SDCE_MISC_INT_EN BIT(1)
+
+/* IO Power control */
+#define IO_PWR_AKEY_ASFAR 0xbaba
+#define IO_PWR_AKEY_ASSAR 0xeb10
+#define IO_PWR_MMC1_PAD_1V8 BIT(2)
struct sdhci_pxa {
struct clk *clk_core;
@@ -128,7 +133,7 @@ static int mv_conf_mbus_windows(struct platform_device *pdev,
}
static int armada_38x_quirks(struct platform_device *pdev,
- struct sdhci_host *host)
+ struct sdhci_host *host)
{
struct device_node *np = pdev->dev.of_node;
struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
@@ -136,8 +141,7 @@ static int armada_38x_quirks(struct platform_device *pdev,
struct resource *res;
host->quirks |= SDHCI_QUIRK_MISSING_CAPS;
- res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
- "conf-sdio3");
+ res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "conf-sdio3");
if (res) {
pxa->sdio3_conf_reg = devm_ioremap_resource(&pdev->dev, res);
if (IS_ERR(pxa->sdio3_conf_reg))
@@ -284,10 +288,10 @@ static void pxav3_set_uhs_signaling(struct sdhci_host *host, unsigned int uhs)
* FE-2946959
*/
if (pxa->sdio3_conf_reg) {
- u8 reg_val = readb(pxa->sdio3_conf_reg);
+ u8 reg_val = readb(pxa->sdio3_conf_reg);
if (uhs == MMC_TIMING_UHS_SDR50 ||
- uhs == MMC_TIMING_UHS_DDR50) {
+ uhs == MMC_TIMING_UHS_DDR50) {
reg_val &= ~SDIO3_CONF_CLK_INV;
reg_val |= SDIO3_CONF_SD_FB_CLK;
} else {
@@ -304,20 +308,20 @@ static void pxav3_set_uhs_signaling(struct sdhci_host *host, unsigned int uhs)
}
static const struct sdhci_ops pxav3_sdhci_ops = {
- .set_clock = sdhci_set_clock,
- .platform_send_init_74_clocks = pxav3_gen_init_74_clocks,
- .get_max_clock = sdhci_pltfm_clk_get_max_clock,
- .set_bus_width = sdhci_set_bus_width,
- .reset = pxav3_reset,
- .set_uhs_signaling = pxav3_set_uhs_signaling,
+ .set_clock = sdhci_set_clock,
+ .platform_send_init_74_clocks = pxav3_gen_init_74_clocks,
+ .get_max_clock = sdhci_pltfm_clk_get_max_clock,
+ .set_bus_width = sdhci_set_bus_width,
+ .reset = pxav3_reset,
+ .set_uhs_signaling = pxav3_set_uhs_signaling,
};
static struct sdhci_pltfm_data sdhci_pxav3_pdata = {
- .quirks = SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK
+ .quirks = SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK
| SDHCI_QUIRK_NO_ENDATTR_IN_NOPDESC
| SDHCI_QUIRK_32BIT_ADMA_SIZE
| SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN,
- .ops = &pxav3_sdhci_ops,
+ .ops = &pxav3_sdhci_ops,
};
#ifdef CONFIG_OF
@@ -343,7 +347,7 @@ static struct sdhci_pxa_platdata *pxav3_get_mmc_pdata(struct device *dev)
return NULL;
if (!of_property_read_u32(np, "mrvl,clk-delay-cycles",
- &clk_delay_cycles))
+ &clk_delay_cycles))
pdata->clk_delay_cycles = clk_delay_cycles;
return pdata;
@@ -433,8 +437,7 @@ static int sdhci_pxav3_probe(struct platform_device *pdev)
host->mmc->pm_caps |= pdata->pm_caps;
if (gpio_is_valid(pdata->ext_cd_gpio)) {
- ret = mmc_gpio_request_cd(host->mmc, pdata->ext_cd_gpio,
- 0);
+ ret = mmc_gpio_request_cd(host->mmc, pdata->ext_cd_gpio, 0);
if (ret) {
dev_err(mmc_dev(host->mmc),
"failed to allocate card detect gpio\n");
--
1.9.1
More information about the linux-arm-kernel
mailing list