[PATCH v3 4/6] [media] c8sectpfe: Update binding to reset-gpios

[Javier Martinez Canillas]

Hello Peter,

On Fri, Aug 28, 2015 at 7:52 PM, Peter Griffin <peter.griffin at linaro.org> wrote:
> gpio.txt documents that GPIO properties should be named
> "[<name>-]gpios", with <name> being the purpose of this
> GPIO for the device.
>
> This change has been done as one atomic commit.
>
> Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
> Acked-by: Lee Jones <lee.jones at linaro.org>
> ---
>  Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt | 6 +++---
>  arch/arm/boot/dts/stihxxx-b2120.dtsi                          | 4 ++--
>  drivers/media/platform/sti/c8sectpfe/c8sectpfe-core.c         | 2 +-
>  3 files changed, 6 insertions(+), 6 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt b/Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt
> index d4def76..e70d840 100644
> --- a/Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt
> +++ b/Documentation/devicetree/bindings/media/stih407-c8sectpfe.txt
> @@ -35,7 +35,7 @@ Required properties (tsin (child) node):
>
>  - tsin-num     : tsin id of the InputBlock (must be between 0 to 6)
>  - i2c-bus      : phandle to the I2C bus DT node which the demodulators & tuners on this tsin channel are connected.
> -- rst-gpio     : reset gpio for this tsin channel.
> +- reset-gpios  : reset gpio for this tsin channel.

The documentation is a bit outdated, the GPIO subsystem supports both
-gpio and -gpios, see commit:

dd34c37aa3e8 ("gpio: of: Allow -gpio suffix for property names")

So it makes sense to me to use -gpio instead of -gpios in this case
since is a single GPIO. Also rst is already a descriptive name since
that's how many datasheets name a reset pin. I'm not saying I'm
against this patch, just pointing out since the commit message is a
bit misleading.

Best regards,
Javier