[PATCH 13/16] arm64: kdump: add kdump support

[AKASHI Takahiro]

Dave,

On 10/23/2015 06:50 PM, Dave Young wrote:
> On 10/22/15 at 06:57pm, AKASHI Takahiro wrote:
>> (added Ard to Cc.)
>>
>> On 10/22/2015 02:15 PM, Dave Young wrote:
>>> On 10/22/15 at 01:29pm, AKASHI Takahiro wrote:
>>>> Hi Dave,
>>>>
>>>> Thank you for your comment.
>>>>
>>>> On 10/22/2015 12:25 PM, Dave Young wrote:
>>>>> Hi, AKASHI,
>>>>>
>>>>> On 10/19/15 at 11:38pm, Geoff Levand wrote:
>>>>>> From: AKASHI Takahiro <takahiro.akashi at linaro.org>
>>>>>>
>>>>>> On crash dump kernel, all the information about primary kernel's core
>>>>>> image is available in elf core header specified by "elfcorehdr=" boot
>>>>>> parameter. reserve_elfcorehdr() will set aside the region to avoid any
>>>>>> corruption by crash dump kernel.
>>>>>>
>>>>>> Crash dump kernel will access the system memory of primary kernel via
>>>>>> copy_oldmem_page(), which reads one page by ioremap'ing it since it does
>>>>>> not reside in linear mapping on crash dump kernel.
>>>>>> Please note that we should add "mem=X[MG]" boot parameter to limit the
>>>>>> memory size and avoid the following assertion at ioremap():
>>>>>> 	if (WARN_ON(pfn_valid(__phys_to_pfn(phys_addr))))
>>>>>> 		return NULL;
>>>>>> when accessing any pages beyond the usable memories of crash dump kernel.
>>>>>
>>>>> How does kexec-tools pass usable memory ranges to kernel? using dtb?
>>>>> Passing an extra mem=X sounds odd in the design. Kdump kernel should get
>>>>> usable ranges and hanle the limit better than depending on an extern kernel
>>>>> param.
>>>>
>>>> Well, regarding "depending on an external kernel param,"
>>>> - this limitation ("mem=") is compatible with arm(32) implementation although
>>>>    it is not clearly described in kernel's Documentation/kdump/kdump.txt.
>>>> - "elfcorehdr" kernel parameter is mandatory on x86 as well as on arm/arm64.
>>>>    The parameter is explicitly generated and added by kexec-tools.
>>>>
>>>> Do I miss your point?
>>>
>>> Arm previously use atag_mem tag for memory kernel uses, with dtb, Booting.txt
>>> says: The boot loader must pass at a minimum the size and location of the
>>> system memory
>>>
>>> In arm64 booting.txt, it does mentions about dtb but without above sentence.
>>>
>>> So if you are using dtb to pass memory I think the extra mem= should be not
>>> necessary unless there's other limitations dtb can not been used.
>>
>> I would expect comments from arm64 maintainers here.
>>
>> In my old implementation, I added "usablemem" attributes, along with "reg," to
>> "memory" nodes in dtb to specify the usable memory region on crash dump kernel.
>>
>> But I removed this feature partly because, on uefi system, uefi might pass
>> no memory information in dtb.
>
> If this is the case there must be somewhere else one can pass memory infomation
> to kernel, the booting.txt should be updated?
>
> kexec as a boot loader need use same method as the 1st kernel boot loader.
>
>>
>>> One thing I'm confused is mem= only pass the memory size, where does you pass
>>> the start addresses?
>>
>> In the current arm64 implementation, any regions below the start address will
>> be ignored as system ram.
>>
>>> What if there's multiple sections such as some reserved
>>> ranges 2nd kernel also need?
>>
>> My patch utilizes only a single contiguous region of memory as system ram.
>> One exception that I notice is uefi's runtime data. They will be ioremap'ed separately.
>>
>> Please let me know if there is any other case that should be supported.
>
> For example the elf headers range, you reserved them in kdump kernel code,
> but kexec-tools can do that early if it can provides all memory info to 2nd
> kernel. Ditto for mark all the memory ranges 1st kernel used as reserved.

It seems to me that the issue you mentioned here is totally independent
from "mem=" issue, isn't it?
(and "elfcorehdr=" is a common way for crash dump kernel to know the region.)

-Takahiro AKASHI

> Thanks
> Dave
>