[PATCH v5] PCI: Xilinx-NWL-PCIe: Added support for Xilinx NWL PCIe Host Controller

[Bjorn Helgaas]

On Wed, Oct 28, 2015 at 10:17:22AM +0000, Bharat Kumar Gogada wrote:
> > On Mon, Oct 26, 2015 at 08:26:26PM +0530, Bharat Kumar Gogada wrote:
> > > Adding PCIe Root Port driver for Xilinx PCIe NWL bridge IP.
> 
> > > +
> > > +	while ((status = nwl_bridge_readl(pcie, MSGF_MSI_STATUS_LO)) !=
> > 0) {
> > > +		for_each_set_bit(bit, &status, 32) {
> > > +			nwl_bridge_writel(pcie, 1 << bit,
> > MSGF_MSI_STATUS_LO);
> > > +			virq = irq_find_mapping(msi->dev_domain, bit);
> > > +			if (virq)
> > > +				generic_handle_irq(virq);
> > > +		}
> > > +	}
> > > +
> > > +	chained_irq_exit(chip, desc);
> > > +}
> > 
> > These are basically identical.  Can you factor them out somehow to avoid
> > repeating the code?
> 
> Is it okay if irq_set_chained_handler_and_data being invoked with two different interrupt numbers, but pointing to 
> same interrupt handler?

Yes, that should be fine.

> > > +
> > > +	pcie->legacy_irq_domain =
> > irq_domain_add_linear(legacy_intc_node, 4,
> > > +
> > 	&legacy_domain_ops,
> > > +							pcie);
> > > +
> > > +	if (!pcie->legacy_irq_domain) {
> > > +		dev_err(pcie->dev, "failed to create IRQ domain\n");
> > > +		return -ENOMEM;
> > > +	}
> > > +
> > > +#ifdef CONFIG_PCI_MSI
> > > +	msi->dev_domain = irq_domain_add_linear(NULL,
> > INT_PCI_MSI_NR,
> > > +					&dev_msi_domain_ops, pcie);
> > > +	if (!msi->dev_domain) {
> > > +		dev_err(pcie->dev, "failed to create dev IRQ domain\n");
> > > +		return -ENOMEM;
> > > +	}
> > > +	msi->msi_chip.domain = pci_msi_create_irq_domain(node,
> > > +
> > 	&nwl_msi_domain_info,
> > > +							msi->dev_domain);
> > > +	if (!msi->msi_chip.domain) {
> > > +		dev_err(pcie->dev, "failed to create msi IRQ domain\n");
> > > +		irq_domain_remove(msi->dev_domain);
> > > +		return -ENOMEM;
> > > +	}
> > > +#endif
> > > +	return 0;
> > > +}
> > > +
> > > +static int nwl_pcie_enable_msi(struct nwl_pcie *pcie, struct pci_bus
> > > +*bus) {
> > 
> > It looks strange to have all the "#ifdef CONFIG_PCI_MSI" above, and here
> > we have this long MSI-related function without any ifdefs around it.  Seems
> > like this should be ifdef'ed also?  What about nwl_pcie_msi_handler_high(),
> > nwl_pcie_msi_handler_low(), nwl_compose_msi_msg(),
> > nwl_msi_set_affinity(), etc.?
> > 
> In probe I'm invoking "nwl_pcie_enable_msi" using "if (IS_ENABLED(CONFIG_PCI_MSI)) " check, since this is at run time 
> I haven't kept above mentioned functions under #ifdef CONFIG_PCI_MSI.
> The above MSI domain allocation was under ifdef, since if driver was compiled for legacy some of the MSI hierarchy API's and structures aren't available.

OK.  It *looks* strange, but maybe it's the best we can do.  I'm not
enamored of IS_ENABLED() thing yet; I guess I just haven't
internalized the combination compile-time and run-time behavior.

Bjorn