[PATCH 2/2] can: xilinx: fix bug in bus error handling

[Kedareswara rao Appana]

Simply resetting the peripheral on bus off condition is not enough,
Because we also need to re-initialize the whole device.
This patch fixes this issue.

Signed-off-by: Kedareswara rao Appana <appanad at xilinx.com>
---
 drivers/net/can/xilinx_can.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/net/can/xilinx_can.c b/drivers/net/can/xilinx_can.c
index 055d6f3..9aeb85f 100644
--- a/drivers/net/can/xilinx_can.c
+++ b/drivers/net/can/xilinx_can.c
@@ -529,6 +529,8 @@ static int xcan_rx(struct net_device *ndev)
 	return 1;
 }
 
+static void xcan_chip_stop(struct net_device *ndev);
+
 /**
  * xcan_err_interrupt - error frame Isr
  * @ndev:	net_device pointer
@@ -558,8 +560,9 @@ static void xcan_err_interrupt(struct net_device *ndev, u32 isr)
 	if (isr & XCAN_IXR_BSOFF_MASK) {
 		priv->can.state = CAN_STATE_BUS_OFF;
 		priv->can.can_stats.bus_off++;
-		/* Leave device in Config Mode in bus-off state */
-		priv->write_reg(priv, XCAN_SRR_OFFSET, XCAN_SRR_RESET_MASK);
+		/* Re-initialize the whole device in bus-off state */
+		xcan_chip_stop(ndev);
+		xcan_chip_start(ndev);
 		can_bus_off(ndev);
 		if (skb)
 			cf->can_id |= CAN_ERR_BUSOFF;
-- 
2.1.2