[PATCH RFC v2 1/2] dt-bindings: simplefb: Support a list of regulator supply properties

[Hans de Goede]

Hi,

On 21-10-15 07:59, Chen-Yu Tsai wrote:
> The physical display tied to the framebuffer may have regulators
> providing power to it, such as power for LCDs or interface conversion
> chips.
>
> The number of regulators in use may vary, but the regulator supply
> binding can not be a list. Work around this by adding a "num-supplies"
> property to communicate the number of supplies, and a list of 0 ~ N
> "vinN-supply" properties for the actual regulator supply.

This bit of the commit message is no longer accurate. Other then that
this patch looks good to me:

Reviewed-by: Hans de Goede <hdegoede at redhat.com>

Regards,

Hans


>
> Signed-off-by: Chen-Yu Tsai <wens at csie.org>
> ---
>   .../devicetree/bindings/video/simple-framebuffer.txt        | 13 +++++++++----
>   1 file changed, 9 insertions(+), 4 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/video/simple-framebuffer.txt b/Documentation/devicetree/bindings/video/simple-framebuffer.txt
> index 4474ef6e0b95..8c9e9f515c87 100644
> --- a/Documentation/devicetree/bindings/video/simple-framebuffer.txt
> +++ b/Documentation/devicetree/bindings/video/simple-framebuffer.txt
> @@ -47,10 +47,14 @@ Required properties:
>     - a8b8g8r8 (32-bit pixels, d[31:24]=a, d[23:16]=b, d[15:8]=g, d[7:0]=r).
>
>   Optional properties:
> -- clocks : List of clocks used by the framebuffer. Clocks listed here
> -           are expected to already be configured correctly. The OS must
> -           ensure these clocks are not modified or disabled while the
> -           simple framebuffer remains active.
> +- clocks : List of clocks used by the framebuffer.
> +- *-supply : Any number of regulators used by the framebuffer. These should
> +	     be named according to the names in the device's design.
> +
> +  The above resources are expected to already be configured correctly.
> +  The OS must ensure they are not modified or disabled while the simple
> +  framebuffer remains active.
> +
>   - display : phandle pointing to the primary display hardware node
>
>   Example:
> @@ -68,6 +72,7 @@ chosen {
>   		stride = <(1600 * 2)>;
>   		format = "r5g6b5";
>   		clocks = <&ahb_gates 36>, <&ahb_gates 43>, <&ahb_gates 44>;
> +		lcd-supply = <&reg_dc1sw>;
>   		display = <&lcdc0>;
>   	};
>   	stdout-path = "display0";
>