[PATCH V2 1/3] Documentation for system mmu in hi6220 platform.

[Mark Rutland]

On Tue, Oct 20, 2015 at 04:45:22PM +0800, Chen Feng wrote:
> docs: iommu: Documentation for smmu in hi6220 SoC.
> 
> Signed-off-by: Chen Feng <puck.chen at hisilicon.com>
> Signed-off-by: Yu Dongbin <yudongbin at hisilicon.com>
> ---
>  .../bindings/iommu/hisi,hi6220-iommu.txt           | 52 ++++++++++++++++++++++
>  1 file changed, 52 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/iommu/hisi,hi6220-iommu.txt
> 
> diff --git a/Documentation/devicetree/bindings/iommu/hisi,hi6220-iommu.txt b/Documentation/devicetree/bindings/iommu/hisi,hi6220-iommu.txt
> new file mode 100644
> index 0000000..93e0701
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/iommu/hisi,hi6220-iommu.txt
> @@ -0,0 +1,52 @@
> +Hi6220 SoC SMMU Device Driver devicetree document
> +=======================================================================
> +The Architecture of SMMU on Hi6220 SoC:
> +
> +   +------------------------------------------------------------------+
> +   |                                                                  |
> +   |         +---------+  +--------+  +-------------+   +-------+     |
> +   |         |   ADE   |  |  ISP   |  |  V/J codec  |   |  G3D  |     |
> +   |         +----|----+  +---|----+  +------|------+   +---|---|     |
> +   |              |           |              |              |         |
> +   |     ---------v-----------v--------------v--------------v-----    |
> +   |                           Media Bus                              |
> +   |     --------------------------------|---------------|--------    |
> +   |                                     |               |            |
> +   |                                 +---v---------------v--------+   |
> +   |                                 |            SMMU            |   |
> +   |                                 +----------|---------|-------+   |
> +   |                                            |         |           |
> +   +--------------------------------------------|---------|-----------+
> +                                                |         |
> +                                   +------------v---------v-----------+
> +                                   |              DDRC                |
> +                                   +----------------------------------+
> +
> +Note:
> +The media system shared the same smmu IP. to access DDR memory. And all

Nit: s/IP./IP/

> +media IP used the same page table.
> +
> +Below binding describes the system mmu for media system in hi6220 platform
> +
> +Required properties:
> +- compatible: Should be "hisilicon,hi6220-smmu" example:
> +		compatible = "hisilicon,hi6220-smmu";

No need for the example here.

Just say:

- compatible: should contain "hisilicon,hi6220-smmu".

> +- reg: A tuple of base address and size of System MMU registers.
> +- interrupts: An interrupt specifier for interrupt signal of System MMU.
> +- clocks: The clock used for smmu IP.
> +- clock-names: The name to enable clock with clock framework.

The description of clocks and clock-names makes no sense.

You must define the exact set of names you expect, and the relationship
between clocks and clock names. e.g.

- clocks: a list of phandle + clock-specifier pairs, one for each entry
  in clock-names

- clock-names: should contain:
  * "smmu_clk"
  * "media_sc_clk"
  * "smmu_peri_clk"

> +- #iommu-cells: The iommu-cells should be 1 for muti-master to use.

s/muti/multi/

You must define what that one cell corresponds to in the hardware.

Thanks,
Mark.

> +
> +Examples:
> +	smmu at f4210000 {
> +		compatible = "hisilicon,hi6220-smmu";
> +		reg = <0x0 0xf4210000 0x0 0x1000>;
> +		interrupts = <GIC_SPI 113 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&sys_ctrl HI6220_MMU_CLK>,
> +		         <&media_ctrl HI6220_MED_MMU>,
> +		         <&sys_ctrl HI6220_MEDIA_PLL_SRC>;
> +		clock-names = "smmu_clk",
> +			      "media_sc_clk",
> +			      "smmu_peri_clk";
> +		#iommu-cells = <1>;
> +	};
> -- 
> 1.9.1
>