[PATCH 3/4] thermal: rockchip: change the TSHUT default state

[Caesar Wang]

As the TRM says, the TSHUT default state is high active.
In general, the TSHUT state can get from the dts. Otherwise
it gets the state from this.

Signed-off-by: Caesar Wang <wxt at rock-chips.com>
---

 drivers/thermal/rockchip_thermal.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/thermal/rockchip_thermal.c b/drivers/thermal/rockchip_thermal.c
index c53e318..776d668 100644
--- a/drivers/thermal/rockchip_thermal.c
+++ b/drivers/thermal/rockchip_thermal.c
@@ -326,7 +326,7 @@ static void rk_tsadcv2_tshut_mode(int chn, void __iomem *regs,
 
 static const struct rockchip_tsadc_chip rk3288_tsadc_data = {
 	.tshut_mode = TSHUT_MODE_GPIO, /* default TSHUT via GPIO give PMIC */
-	.tshut_polarity = TSHUT_LOW_ACTIVE, /* default TSHUT LOW ACTIVE */
+	.tshut_polarity = TSHUT_HIGH_ACTIVE, /* default TSHUT HIGH ACTIVE */
 	.tshut_temp = 95000,
 
 	.initialize = rk_tsadcv2_initialize,
-- 
1.9.1