[PATCH] ARM: at91/dt: add pullup on mmc2 data signals

[Nicolas Ferre]

Le 07/09/2015 17:47, Sylvain Rochet a écrit :
> MMC data lines may be left floating if nothing is currently driving the
> data lines, which is the case when mmc is in idle state, thus consuming
> a useless extra amount of power. Add pullup on mmc2 data signals in the
> same way it was previously done for mmc0 and mmc1.
> 
> Signed-off-by: Sylvain Rochet <sylvain.rochet at finsecur.com>

Acked-by: Nicolas Ferre <nicolas.ferre at atmel.com>

Thanks Sylvain!

> ---
>  arch/arm/boot/dts/sama5d3_mci2.dtsi | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/sama5d3_mci2.dtsi b/arch/arm/boot/dts/sama5d3_mci2.dtsi
> index 026b252..e21099a 100644
> --- a/arch/arm/boot/dts/sama5d3_mci2.dtsi
> +++ b/arch/arm/boot/dts/sama5d3_mci2.dtsi
> @@ -24,9 +24,9 @@
>  					};
>  					pinctrl_mmc2_dat1_3: mmc2_dat1_3 {
>  						atmel,pins =
> -							<AT91_PIOC 12 AT91_PERIPH_A AT91_PINCTRL_NONE	/* PC12 periph A MCI2_DA1 with pullup, conflicts with TIOA1 */
> -							 AT91_PIOC 13 AT91_PERIPH_A AT91_PINCTRL_NONE	/* PC13 periph A MCI2_DA2 with pullup, conflicts with TIOB1 */
> -							 AT91_PIOC 14 AT91_PERIPH_A AT91_PINCTRL_NONE>;	/* PC14 periph A MCI2_DA3 with pullup, conflicts with TCLK1 */
> +							<AT91_PIOC 12 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PC12 periph A MCI2_DA1 with pullup, conflicts with TIOA1 */
> +							 AT91_PIOC 13 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PC13 periph A MCI2_DA2 with pullup, conflicts with TIOB1 */
> +							 AT91_PIOC 14 AT91_PERIPH_A AT91_PINCTRL_PULL_UP>;	/* PC14 periph A MCI2_DA3 with pullup, conflicts with TCLK1 */
>  					};
>  				};
>  			};
> 


-- 
Nicolas Ferre