[PATCH 0/9] Add STM32 EXTI interrupt controller support
Maxime Coquelin
mcoquelin.stm32 at gmail.com
Sat Oct 17 10:23:49 PDT 2015
This series adds support to EXTI interrupt controller and GPIO IRQ support in
STM32 pinctrl driver.
The STM32 external interrupt controller consists of edge detectors that
generate interrupts requests or wake-up events.
Each line can be independently configured as interrupt or wake-up source,
and triggers either on rising, fallin or both edges. Each line can also
be masked independently.
This series applies on top of STM32 pinctrl v2 series.
Regards,
Maxime
Maxime Coquelin (9):
Documentation: dt-bindings: Document STM32 EXTI controller bindings
drivers: irqchip: Add STM32 external interrupts support
ARM: STM32: Select external interrupts controller
ARM: dts: Add EXTI controller node to stm32f429
Documentation: dt-bindings: Add IRQ related properties of STM32
pinctrl
pinctrl: Add IRQ support to STM32 gpios
ARM: dts: Add GPIO irq support to STM2F429
ARM: dts: Declare push button as GPIO key on stm32f429 Disco board
ARM: config: Enable GPIO Key driver in stm32_defconfig
.../interrupt-controller/st,stm32-exti.txt | 20 +++
.../bindings/pinctrl/st,stm32-pinctrl.txt | 3 +
arch/arm/Kconfig | 1 +
arch/arm/boot/dts/stm32429i-eval.dts | 19 +++
arch/arm/boot/dts/stm32f429-disco.dts | 13 ++
arch/arm/boot/dts/stm32f429.dtsi | 15 ++
arch/arm/configs/stm32_defconfig | 6 +-
drivers/irqchip/Kconfig | 4 +
drivers/irqchip/Makefile | 1 +
drivers/irqchip/irq-stm32-exti.c | 169 +++++++++++++++++++++
drivers/pinctrl/stm32/Kconfig | 1 +
drivers/pinctrl/stm32/pinctrl-stm32.c | 68 +++++++++
12 files changed, 319 insertions(+), 1 deletion(-)
create mode 100644 Documentation/devicetree/bindings/interrupt-controller/st,stm32-exti.txt
create mode 100644 drivers/irqchip/irq-stm32-exti.c
--
1.9.1
More information about the linux-arm-kernel
mailing list