[PATCH] ARM: keystone: dts: add PCI serdes driver bindings

[WingMan Kwok]

This patch adds the required PCI serdes bindings whcih can then be
enabled by setting the corresponding statuses to "ok" in order to
configure and start the PCI serdes.

This patch depends on the updates to the Keystone PCIe host driver
and common serdes driver patch series that is submitted separately.

Signed-off-by: WingMan Kwok <w-kwok2 at ti.com>
---
 arch/arm/boot/dts/k2e.dtsi      |   21 +++++++++++++++++++++
 arch/arm/boot/dts/keystone.dtsi |   21 +++++++++++++++++++++
 2 files changed, 42 insertions(+)

diff --git a/arch/arm/boot/dts/k2e.dtsi b/arch/arm/boot/dts/k2e.dtsi
index 675fb8e..3b36575 100644
--- a/arch/arm/boot/dts/k2e.dtsi
+++ b/arch/arm/boot/dts/k2e.dtsi
@@ -86,6 +86,16 @@
 			gpio,syscon-dev = <&devctrl 0x240>;
 		};
 
+		pcie1_phy: pciephy at 2326000 {
+			#phy-cells = <0>;
+			compatible = "ti,keystone-serdes-pcie";
+			reg = <0x02326000 0x4000>;
+			reg-names = "serdes";
+			link-rate-kbps = <5000000>;
+			num-lanes = <2>;
+			status = "disabled";
+		};
+
 		pcie1: pcie at 21020000 {
 			compatible = "ti,keystone-pcie","snps,dw-pcie";
 			clocks = <&clkpcie1>;
@@ -130,6 +140,17 @@
 					<GIC_SPI 375 IRQ_TYPE_EDGE_RISING>,
 					<GIC_SPI 376 IRQ_TYPE_EDGE_RISING>;
 			};
+
+			/* PCIE phy */
+			serdeses {
+				#address-cells = <1>;
+				#size-cells = <0>;
+				serdes at 0 {
+					reg = <0>;
+					phys = <&pcie1_phy>;
+				};
+			};
+
 		};
 
 		mdio: mdio at 24200f00 {
diff --git a/arch/arm/boot/dts/keystone.dtsi b/arch/arm/boot/dts/keystone.dtsi
index 72816d6..6566cc4 100644
--- a/arch/arm/boot/dts/keystone.dtsi
+++ b/arch/arm/boot/dts/keystone.dtsi
@@ -275,6 +275,16 @@
 			ti,syscon-dev = <&devctrl 0x2a0>;
 		};
 
+		pcie0_phy: pciephy at 2320000 {
+			#phy-cells = <0>;
+			compatible = "ti,keystone-serdes-pcie";
+			reg = <0x02320000 0x4000>;
+			reg-names = "serdes";
+			link-rate-kbps = <5000000>;
+			num-lanes = <2>;
+			status = "disabled";
+		};
+
 		pcie0: pcie at 21800000 {
 			compatible = "ti,keystone-pcie", "snps,dw-pcie";
 			clocks = <&clkpcie>;
@@ -319,6 +329,17 @@
 					<GIC_SPI 28 IRQ_TYPE_EDGE_RISING>,
 					<GIC_SPI 29 IRQ_TYPE_EDGE_RISING>;
 			};
+
+			/* PCIE phy */
+			serdeses {
+				#address-cells = <1>;
+				#size-cells = <0>;
+				serdes at 0 {
+					reg = <0>;
+					phys = <&pcie0_phy>;
+				};
+			};
+
 		};
 	};
 };
-- 
1.7.9.5