[PATCH v2 2/5] mmc: sdhci-pxav3: enable usage of DAT3 pin as HW card detect

[Jisheng Zhang]

Hi Marcin,

On Fri, 9 Oct 2015 16:45:25 +0200
Marcin Wojtas <mw at semihalf.com> wrote:

> Jisheng,
> 
> 
> >>
> >> When using DAT3-based detection Armada 38x SDIO IP expects its internal
> >> clock to be always on, which had to be ensured twofold:
> >
> > What happen if runtime suspend disables its core clk and axi clk? I guess
> > dat3-based detection isn't compatible with runtime pm. If so, do we also
> > need to disable runtime pm in probe function?
> 
> Is runtime resume supposed to be triggered by card detection? Is there

I think so. Take marvell berlin for example, card insert => gpio interrupt
or => sdhci runtime resume.

> a way to manually trigger runtime suspend and resume of sdhci? Anyway

If runtime-pm is builtin and the host driver supports runtime-pm (sdhci-pxav3
supports runtime-pm well), when there's no sdhc transactions, runtime suspend
will be triggered automatically after some time (50ms?)

> coreclk is not a problem, as it's not used by A38x.

I checked A38x dts files, it's <&gateclk 17>. So the question is: what will
happen if <&gateclk 17> is disabled in runtime suspend? Is the dat3-based
CD still works? In theory, it should not work any more.

> 
> >
> >> - Each time controller is reset by updating appropriate registers. On the
> >>   occasion of adding new register @0x104, register @0x100 name is modified
> >>   in order to the be aligned with Armada 38x documentation.
> >> - Leaving the clock enabled despite power-down. For this purpose a new
> >>   quirk had to be added to SDHCI subsystem - SDHCI_QUIRK2_KEEP_INT_CLK_ON.
> >
> > As seen from other mails, Ulf calls for no more quirks...
> >
> 
> Ok, I'll try to find another solution.
> 
> Best regards,
> Marcin