[PATCH 3/3] hwrng: st: Use real-world device timings for timeout

[Russell King - ARM Linux]

On Tue, Oct 06, 2015 at 09:51:22PM +0100, Lee Jones wrote:
> On Tue, 06 Oct 2015, Russell King - ARM Linux wrote:
> > On Tue, Oct 06, 2015 at 03:44:00PM +0100, Lee Jones wrote:
> > > Samples are documented to be available every 0.667us, so in theory
> > > the 8 sample deep FIFO should take 5.336us to fill.  However, during
> > > thorough testing, it became apparent that filling the FIFO actually
> > > takes closer to 12us.
> > 
> > Is that measured?
> 
> I measured it using ktime.  Hopefully that was adequate.
> 
> > > +/*
> > > + * Samples are documented to be available every 0.667us, so in theory
> > > + * the 8 sample deep FIFO should take 5.336us to fill.  However, during
> > > + * thorough testing, it became apparent that filling the FIFO actually
> > > + * takes closer to 12us.
> > > + */
> > > +#define ST_RNG_FILL_FIFO_TIMEOUT	12
> > 
> > I hope you're not using such a precise figure with udelay().  udelay()
> > is not guaranteed to give exactly (or even at least) the delay you
> > request.  It's defined to give an approximate delay.
> > 
> > Many people have a problem understanding that, so I won't explain why
> > it is that way, just accept that it is and move on... it's not going
> > to magically get "fixed" because someone has just learnt about this. :)
> 
> Thanks for the info.  I did do testing, again using ktime, to make
> sure and on our platform (is it platform specific?) I measured
> udelay(1) to be ~1100ns.  After moving to a 12us timeout and reading
> many MBs of randomness I am yet to receive any more timeouts.

If you happen to fall back to the software timing loop, udelay(1) will not
be >=1us anymore, but will be slightly shorter.

That's because the loops_per_jiffy value is calculated as the number of
loops between each timer interrupt - so the period being measured is the
timer period, minus the time it takes for the timer interrupt to run.
The latter is indeterminant.  Consequently, the loops_per_jiffy estimate
is always slightly under the real number of loops-per-jiffy, so delays
generated by udelay() and friends will always be slightly short.

The faster your HZ value, the bigger the error.  The longer the interrupt
handler takes, the bigger the error.

IIRC, Linus recommends a x2 factor on delays, especially timeouts generated
by these functions.

-- 
FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up
according to speedtest.net.