[PATCH 4/5] Documentation: dt-bindings: Add info about brcm, nand-iproc-reset DT flag

[Anup Patel]

This patch updates the BRCM NAND controller DT bindings documentation
to add info about newly added optional flag "brcm,nand-iproc-reset".

Signed-off-by: Anup Patel <anup.patel at broadcom.com>
Reviewed-by: Pramod KUMAR <pramodku at broadcom.com>
Reviewed-by: Ray Jui <rjui at broadcom.com>
Reviewed-by: Scott Branden <sbranden at broadcom.com>
---
 Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
index 4ff7128..19b7a3c 100644
--- a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
+++ b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
@@ -78,6 +78,10 @@ we define additional 'compatible' properties and associated register resources w
        for interrupt status/ack.
      - reg-names: (required) a list of the names corresponding to the previous
        register ranges. Should contain "iproc-idm" and "iproc-ext".
+     - brcm,nand-iproc-reset: (optional) Some of the Broadcom IPROC SoCs
+       require NAND controller to be resetted for cleanup of previously
+       configured NAND controller state. This optional flag resets the
+       NAND controller once before any NAND commands are issued.
 
 
 * NAND chip-select
-- 
1.9.1