[PATCH v7 0/5] ARM: berlin: PWM support

[Antoine Tenart]

Hi all,

This series adds a driver for the Marvell Berlin PWM controller, which
has 4 channels.

This has been tested on a BG2Q DMP.

Thanks,

Antoine

Changes since v6:
        - Used a prescaler_table again
        - Removed the spinlock
        - Used inline function for read/write
        - Always disable the clock in _remvove()
        - Cosmtic updates
	- Reordered the Documentation patch

Changes since v5:
        - Rebased on top of 4.3-rc1
        - Added a call to clk_disable_unprepare() in case of failure

Changes since v4:
        - Reworked _remove()
        - Reworked _enable()

Changes since v3:
        - Use readl_relaxed
        - Reworked the clk enable / clk disable calls
        - Removed BERLIN_PWM_DISABLE

Changes since v2:
        - Reworked the prescaler/tcnt calculation
        - Added an input clock
        - Updated the documentation
        - Reordered the pwm node
        - Added some definition for BIT()

Changes since v1:
        - Added a sentinel in berlin_pwm_match[]

Antoine Tenart (5):
  Documentation: bindings: document the Berlin PWM driver
  pwm: add the Berlin pwm controller driver
  ARM: berlin: add a PWM node on the BG2Q
  ARM: berlin: add a PWM node on the BG2
  ARM: berlin: add a PWM node on the BG2CD

 .../devicetree/bindings/pwm/pwm-berlin.txt         |  17 ++
 arch/arm/boot/dts/berlin2.dtsi                     |   7 +
 arch/arm/boot/dts/berlin2cd.dtsi                   |   7 +
 arch/arm/boot/dts/berlin2q.dtsi                    |   7 +
 drivers/pwm/Kconfig                                |   9 +
 drivers/pwm/Makefile                               |   1 +
 drivers/pwm/pwm-berlin.c                           | 221 +++++++++++++++++++++
 7 files changed, 269 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pwm/pwm-berlin.txt
 create mode 100644 drivers/pwm/pwm-berlin.c

-- 
2.6.0