[PATCH v4 1/8] thermal: qcom: tsens: Add a skeletal TSENS drivers

[Rajendra Nayak]

[]..

>>> +Optional properties:
>>> +- qcom,sensor-id: List of sensor instances used in a given SoC. A TSENS IP can
>>> +		  have a fixed number of sensors (like 11) but a given SoC can
>>> +		  use only 5 of these and they might not always the first 5. They
>>> +		  could be sensors 0, 1, 4, 8 and 9. This property is used to
>>> +		  describe the subset of the sensors used. If this property is
>>> +		  missing they are assumed to be the first 'n' sensors numbered
>>> +		  sequentially in which case the number of sensors defaults to
>>> +		  the number of slope values.
>>
>> Can you please elaborate a bit more on why you could not solve this
>> using the thermal sensor descriptor id?
>>
>>> +
>>> +Example:
>>> +tsens: thermal-sensor at 900000 {
>>> +		compatible = "qcom,msm8916-tsens";
>>> +		nvmem-cells = <&tsens_caldata>, <&tsens_calsel>;
>>> +		nvmem-cell-names = "caldata", "calsel";
>>> +		qcom,tsens-slopes = <3200 3200 3200 3200 3200>;
>>


>>> +		qcom,sensor-id = <0 1 2 4 5>;
>>> +		#thermal-sensor-cells = <1>;
>>
>> How about if you simply make the sensor driver expose all sensors, then in the
>> thermal zone descriptor, you pick which sensor to use using the thermal sensor
>> descriptor (quoting the binding again):

Hi Eduardo,

What you suggested would work, except for that the calibration data in eeprom would
be available for only the _subset_ of sensors on the SoC. So the driver in some way would
need to know which exact sensors the eeprom data corresponds to.

If this does not seem like something which needs to be described in DT, I can have the 
data embedded into the driver so it gets picked based on the right compatibles.

regards,
Rajendra

>>
>> ocp {
>>         ...
>>         /*
>>          * A simple IC with several bandgap temperature sensors.
>>          */
>>         bandgap0: bandgap at 0x0000ED00 {
>>                 ...
>>                 #thermal-sensor-cells = <1>;
>>         };
>> };
>>
>> thermal-zones {
>>         cpu_thermal: cpu-thermal {
>>                 polling-delay-passive = <250>; /* milliseconds */
>>                 polling-delay = <1000>; /* milliseconds */
>>
>>                                 /* sensor       ID */
>>                 thermal-sensors = <&bandgap0     0>;
>> 	};
>> 	gpu_thermal: gpu-thermal {
>>                 polling-delay-passive = <120>; /* milliseconds */
>>                 polling-delay = <1000>; /* milliseconds */
>>
>>                                 /* sensor       ID */
>>                 thermal-sensors = <&bandgap0     1>;
>>
>> 	};
>>
>> };
>>
>> Would that simplify ?
>>
>> BR,
>>
>> Eduardo Valentin


-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by The Linux Foundation