[PATCH V2 2/2] ARM: dts: imx6q: add Novena board

[Lucas Stach]

Am Freitag, den 20.11.2015, 21:46 +0100 schrieb Marek Vasut:
> From: Sean Cross <xobs at kosagi.com>
> 
> Novena is an open-hardware laptop/desktop/bare board.
> 
> See http://www.kosagi.com/w/index.php?title=Novena_Main_Page
> 
> Signed-off-by: Sean Cross <xobs at kosagi.com>
> Cc: Fabio Estevam <fabio.estevam at freescale.com>
> Cc: Lucas Stach <l.stach at pengutronix.de>
> Cc: Sean Cross <xobs at kosagi.com>
> Cc: Shawn Guo <shawnguo at kernel.org>
> ---
>  arch/arm/boot/dts/Makefile         |   1 +
>  arch/arm/boot/dts/imx6q-novena.dts | 856 +++++++++++++++++++++++++++++++++++++
>  2 files changed, 857 insertions(+)
>  create mode 100644 arch/arm/boot/dts/imx6q-novena.dts
> 
> V2: Fix the PCIe regulator, make it always on
>     Fix the polarity of SD2 WP and CD lines, make them active low.
>     Drop the simple-bus for regulators, put them in /soc instead.

Huh? No. The fixed and GPIO controlled regulators are certainly not part
of the SoC. They are board level components and belong into the same DT
hierarchy level as the sound codec and leds.

Otherwise looks good now.

Regards,
Lucas

-- 
Pengutronix e.K.             | Lucas Stach                 |
Industrial Linux Solutions   | http://www.pengutronix.de/  |