[PATCH v9 3/6] target-arm: kvm - support for single step

Peter Maydell peter.maydell at linaro.org
Fri Nov 20 07:30:34 PST 2015


On 12 November 2015 at 16:20, Alex Bennée <alex.bennee at linaro.org> wrote:
> This adds support for single-step. There isn't much to do on the QEMU
> side as after we set-up the request for single step via the debug ioctl
> it is all handled within the kernel.
>
> Signed-off-by: Alex Bennée <alex.bennee at linaro.org>
>
> ---
> v2
>   - convert to using HSR_EC
> v3
>   - use internals.h definitions
> ---
>  target-arm/kvm.c | 10 ++++++++++
>  1 file changed, 10 insertions(+)
>
> diff --git a/target-arm/kvm.c b/target-arm/kvm.c
> index 50f70ef..d505a7e 100644
> --- a/target-arm/kvm.c
> +++ b/target-arm/kvm.c
> @@ -535,6 +535,13 @@ static int kvm_handle_debug(CPUState *cs, struct kvm_run *run)
>      kvm_cpu_synchronize_state(cs);
>
>      switch (hsr_ec) {
> +    case EC_SOFTWARESTEP:
> +        if (cs->singlestep_enabled) {
> +            return true;
> +        } else {
> +            error_report("Came out of SINGLE STEP when not enabled");
> +        }
> +        break;
>      case EC_AA64_BKPT:
>          if (kvm_find_sw_breakpoint(cs, env->pc)) {
>              return true;
> @@ -595,6 +602,9 @@ int kvm_arch_on_sigbus(int code, void *addr)
>
>  void kvm_arch_update_guest_debug(CPUState *cs, struct kvm_guest_debug *dbg)
>  {
> +    if (cs->singlestep_enabled) {
> +        dbg->control |= KVM_GUESTDBG_ENABLE | KVM_GUESTDBG_SINGLESTEP;
> +    }

Doesn't kvm_update_guest_debug() already set these bits, or am
I misreading it?

>      if (kvm_sw_breakpoints_active(cs)) {
>          dbg->control |= KVM_GUESTDBG_ENABLE | KVM_GUESTDBG_USE_SW_BP;
>      }
> --
> 2.6.3

thanks
-- PMM



More information about the linux-arm-kernel mailing list