[PATCH 14/29] ARM: shmobile: gose: Configure PFC in DT

[Simon Horman]

Configure PFC for the already enabled scif and ethernet devices
in the device tree for the gose board.

Based on similar work for the koelsch board by Laurent Pinchart and
Sergei Shtylyov.

Signed-off-by: Simon Horman <horms+renesas at verge.net.au>
Acked-by: Laurent Pinchart <laurent.pinchart+renesas at ideasonboard.com>
---
 arch/arm/boot/dts/r8a7793-gose.dts | 31 +++++++++++++++++++++++++++++++
 1 file changed, 31 insertions(+)

diff --git a/arch/arm/boot/dts/r8a7793-gose.dts b/arch/arm/boot/dts/r8a7793-gose.dts
index 96443ec5f6ab..1575ef759047 100644
--- a/arch/arm/boot/dts/r8a7793-gose.dts
+++ b/arch/arm/boot/dts/r8a7793-gose.dts
@@ -37,7 +37,32 @@
 	clock-frequency = <20000000>;
 };
 
+&pfc {
+	scif0_pins: serial0 {
+		renesas,groups = "scif0_data_d";
+		renesas,function = "scif0";
+	};
+
+	scif1_pins: serial1 {
+		renesas,groups = "scif1_data_d";
+		renesas,function = "scif1";
+	};
+
+	ether_pins: ether {
+		renesas,groups = "eth_link", "eth_mdio", "eth_rmii";
+		renesas,function = "eth";
+	};
+
+	phy1_pins: phy1 {
+		renesas,groups = "intc_irq0";
+		renesas,function = "intc";
+	};
+};
+
 &ether {
+	pinctrl-0 = <&ether_pins &phy1_pins>;
+	pinctrl-names = "default";
+
 	phy-handle = <&phy1>;
 	renesas,ether-link-active-low;
 	status = "okay";
@@ -55,9 +80,15 @@
 };
 
 &scif0 {
+	pinctrl-0 = <&scif0_pins>;
+	pinctrl-names = "default";
+
 	status = "okay";
 };
 
 &scif1 {
+	pinctrl-0 = <&scif1_pins>;
+	pinctrl-names = "default";
+
 	status = "okay";
 };
-- 
2.1.4