[PATCH] clocksource/drivers/tango-xtal: Replace code by clocksource_mmio_init

[Måns Rullgård]

Marc Gonzalez <marc_gonzalez at sigmadesigns.com> writes:

> On 17/11/2015 13:22, Daniel Lezcano wrote:
>> On 11/13/2015 01:20 PM, Marc Gonzalez wrote:
>>> On 13/11/2015 11:58, Daniel Lezcano wrote:
>>>
>>>> The current code to initialize, register and read the clocksource is
>>>> already factored out in mmio.c via the clocksource_mmio_init function.
>>>>
>>>> Factor out the code with the clocksource_mmio_init function.
>>>
>>> The reason I didn't like clocksource_mmio_init() is because it exports
>>> 4 generic accessors.
>>>
>>> I guess this function makes more sense when all platforms are using it,
>>> in an ARCH_MULTIPLATFORM kernel. (Also the accessors are probably quite
>>> small, so the waste is probably minimal.)
>> 
>> Hi Marc,
>> 
>> it is not clear for me if you agree with this patch or not. Can you 
>> clarify ?
>
> [ Adding rmk as the original mmio.c author ]
>
> Hello Daniel,
>
> It's hard to give a straight answer. From my limited perspective (building
> a kernel for Sigma boards only) I feel that mmio.c brings nothing. (As you
> mentioned, it would be interesting to measure whether having reg_base in
> the ctx, rather than as a global is better or worse for perf, though the
> actual difference may be lost in the noise.)
>
> On the other hand, I can see how a different perspective, such as yours,
> may see benefits in having all drivers use the same APIs; and there may
> be other savings for ARCH_MULTIPLATFORM builds with lots of platforms.

I think the patch is good.  If there are issues with clocksource_mmio
those should addressed separately.

-- 
Måns Rullgård
mans at mansr.com