[PATCH] PCI: imx6:don't sleep in atomic context

[Sharma, Sanjeev]

On Tuesday 10 November 2015 10:35:10 Lucas Stach wrote:
> Am Dienstag, den 10.11.2015, 10:28 +0100 schrieb Arnd Bergmann:
> > On Tuesday 10 November 2015 09:41:18 Lucas Stach wrote:
> > > > diff --git a/drivers/pci/host/pci-imx6.c 
> > > > b/drivers/pci/host/pci-imx6.c index 233a196..9769b13 100644
> > > > --- a/drivers/pci/host/pci-imx6.c
> > > > +++ b/drivers/pci/host/pci-imx6.c
> > > > @@ -499,7 +499,7 @@ static int imx6_pcie_link_up(struct pcie_port *pp)
> > > >                * Wait a little bit, then re-check if the link finished
> > > >                * the training.
> > > >                */
> > > > -             usleep_range(1000, 2000);
> > > > +             mdelay(1000);
> > > 
> > > A mdelay(1000) is a whole different timescale than a usleep(1000). 
> > > If this patch works for you with mdelay(1) or maybe mdelay(2) I 
> > > would be fine with it.
> > 
> > mdelay(1) is still a really long time to block the CPU for, on 
> > potentially every config space access.
> > 
> > Everybody else just returns the link status here, which seems to be 
> > the better alternative. If you need to delay the startup, better 
> > have a msleep(1) loop in the initial probe function where you are 
> > allowed to sleep.
> > 
> Yes, it's somewhere on my TODO list to rework the link-up handling 
> here, but as there are quite a few timing and ordering implications in 
> that code, this needs a good thought and a good deal of testing. So 
> I'm inclined to ACK the current patch to get rid of the obvious bug 
> and sort things out properly in a follow on patchset.

Maybe use that patch with some modifications then:

* add a comment to explain that this is currently called from possibly
  atomic context through pci_config_{read,write} and that the link
  state handling never belonged here.

* instead of looping five times for up to 2ms each, loop 100 times
  around a udelay(20) to hopefully be done earlier. I was going to
  suggest using time_before(timeout, jiffies) as the condition to
  wait for, but that doesn't work if called with interrupts disabled.

	Arnd
Shall I go ahead by changing only current patch to mdelay(1). I will also
Incorporate comment  #1 given by Arnd above.