[PATCH 2/2] ARM: shmobile: gose: Configure PFC in DT

Simon Horman horms+renesas at verge.net.au
Sun Nov 8 17:33:19 PST 2015


Configure PFC for the already enabled scif and ethernet devices
in the device tree for the gose board.

Based on similar work for the koelsch board by Laurent Pinchart and
Sergei Shtylyov.

Cc: Laurent Pinchart <laurent.pinchart+renesas at ideasonboard.com>
Cc: Sergei Shtylyov <sergei.shtylyov at cogentembedded.com>
Signed-off-by: Simon Horman <horms+renesas at verge.net.au>
---
 arch/arm/boot/dts/r8a7793-gose.dts | 31 +++++++++++++++++++++++++++++++
 1 file changed, 31 insertions(+)

diff --git a/arch/arm/boot/dts/r8a7793-gose.dts b/arch/arm/boot/dts/r8a7793-gose.dts
index 96443ec5f6ab..1575ef759047 100644
--- a/arch/arm/boot/dts/r8a7793-gose.dts
+++ b/arch/arm/boot/dts/r8a7793-gose.dts
@@ -37,7 +37,32 @@
 	clock-frequency = <20000000>;
 };
 
+&pfc {
+	scif0_pins: serial0 {
+		renesas,groups = "scif0_data_d";
+		renesas,function = "scif0";
+	};
+
+	scif1_pins: serial1 {
+		renesas,groups = "scif1_data_d";
+		renesas,function = "scif1";
+	};
+
+	ether_pins: ether {
+		renesas,groups = "eth_link", "eth_mdio", "eth_rmii";
+		renesas,function = "eth";
+	};
+
+	phy1_pins: phy1 {
+		renesas,groups = "intc_irq0";
+		renesas,function = "intc";
+	};
+};
+
 &ether {
+	pinctrl-0 = <&ether_pins &phy1_pins>;
+	pinctrl-names = "default";
+
 	phy-handle = <&phy1>;
 	renesas,ether-link-active-low;
 	status = "okay";
@@ -55,9 +80,15 @@
 };
 
 &scif0 {
+	pinctrl-0 = <&scif0_pins>;
+	pinctrl-names = "default";
+
 	status = "okay";
 };
 
 &scif1 {
+	pinctrl-0 = <&scif1_pins>;
+	pinctrl-names = "default";
+
 	status = "okay";
 };
-- 
2.1.4




More information about the linux-arm-kernel mailing list